Thread these fittings into motors, bearings, engine blocks, and other machinery to create a lubrication point.

Keep thin grease from leaking out—the check valve on these fittings has a Buna-N seat that creates a tighter seal than check valves on other grease fittings.

Prevent damage to bearing seals caused by over-lubrication—these fittings automatically stop grease flow when pressure is within the shut-off range.

Often used on earth movers, mining equipment, and other heavy machinery, these fittings have a T-shaped top that holds the dispensing tip in place so it won't pop off when adding grease.

Drive these fittings into unthreaded holes.

Since they don’t protrude, these fittings avoid damage from impact and fit in tight spaces. Use a hammer and grease fitting installation tool to drive them into unthreaded holes.

When the size or thread type of a fitting doesn't match an existing opening, use these adapters to make the connection.

Tap these tools once or twice with a hammer to install fittings.

Remove worn fittings and repair threaded holes.

Choose these blocks if you need to lubricate multiple points but need to control how each is greased. Unlike grease fitting manifolds, these blocks have multiple fittings, so you control what each point receives and when.

Dispense from grease guns into grease fittings and bare lubrication points.

Dispense from grease guns into grease fittings and bare lubrication points.

These rigid tip adapters penetrate gaskets, sealed bearings, and joints to deliver grease to precise locations.

These flexible extensions have a quick-disconnect fitting that snaps into your dispensing tip, so you can lubricate grease fittings that are hard to reach.

Be sure you’re using the right grease—this gun has a clear barrel for identification at a glance.

Turn a small tube of grease into a dispenser.

Switch between high-pressure and low-pressure settings. Use high pressure to dispense thicker grease or to force grease through clogged fittings. Use low pressure for high-volume dispensing.

Dispense grease with the highest-pressure-rated gun we offer.

Designed to lubricate linear motion components, such as slide bearings, guides, and ball screws, these guns work exclusively with THK grease cartridges and fittings.

Ensure that only food-grade grease is used in controlled areas—this gun only works with compatible food-grade grease cartridges.

Be sure you’re using the right grease—this gun has a clear barrel for identification at a glance.

Switch between high-pressure and low-pressure settings. Use high pressure to dispense thicker grease or to force grease through clogged fittings. Use low pressure for high-volume dispensing.

This gun comes filled with 2 oz. of lithium-thickened grease.

Use compressed air to dispense grease.

A display allows you to monitor how much grease is dispensed.