Stainless Steel Precision Shafts

Filter by

Material

System of Measurement

Diameter

Length

End Type

Mechanical Finish

Edge Type

Shaft Motion

Hardness Rating

Hardness

Shaft Diameter

Thread Size

Shape

Keyway Length

REACH Compliance

Heat Treatment

RoHS Compliance

DFARS Compliance

Keyway Width

Surface Smoothness

Component

D-Profile Length

Overall Length

Forward

How can we improve?

984 Products

About Shafts

Rotary Shafts

Combine these general purpose drive shafts with gears, sprockets, and bearings to transmit rotary motion.

D-Profile Rotary Shafts

A flat surface area allows set screws to dig into the shaft for securely mounting gears, sprockets, and bearings.

Keyed Rotary Shafts

Combine with a machine key to transmit torque to gears, sprockets, and other power transmission components.

Partially Keyed Rotary Shafts

These shafts have keyways only on the ends, leaving a plain shaft in the center. Use the keyways with machine keys to transmit torque to gears, sprockets, and other keyed components. Use the middle of the shaft with bearings and other round-bore components.

Undersized Rotary Shafts

The diameter of these shafts is slightly smaller than listed, so precision ball bearings (ABEC-3 and above) slide on without any tools.

Rotary Shafts with Retaining Ring Grooves

Clip retaining rings into the grooves to separate and position gears, sprockets, and bearings.

Step-Down Rotary Shafts

A shoulder near the end of the shaft provides a stop for gears, sprockets, and bearings.

Linear Motion Shafts

Combine these general purpose shafts with a linear bearing and shaft support to create a basic linear motion system.

Tapped Linear Motion Shafts

Internal threads allow you to mount these shafts onto threaded studs and fasteners, no shaft supports needed.

Easy-Access Base-Mounted Shaft Supports

Made with two pieces, these shaft supports secure your shaft parallel to your mounting surface and make it easy to access the shaft without having to slide it out or uninstall the support. Use these supports when working with light to medium loads where shaft alignment is not critical.

Easy-Access Flange-Mounted Shaft Supports

A removable collar allows access to the shaft without unbolting the flange. For use with light to medium loads where shaft alignment is not critical, these supports allow you to hold linear shafts perpendicular to the mounting surface. Secure the shaft by tightening the clamping screw.

Support-Rail Shafts

These shafts include a support rail for a stable setup that eliminates bending and prevents linear bearings from rotating.

Shafts for Support Rails

Replace worn shafts in two-piece support-rail shaft systems, or mate with a support rail to create your own. The tapped mounting holes match those on our Support Rails.