The grit particles are block shaped and cut slowly to produce a polished surface on metals.

These rolls are coated with aluminum oxide, which is the most common abrasive material and hard enough to sand steel and wood.

The grit particles are block shaped and cut slowly.

These rolls resist deterioration when used wet or with grease, chemicals, cutting fluids, and other solvents that may be present when sanding.

A slick coating on these rolls prevents debris from accumulating on the abrasive surface and keeps operating temperatures low.

Flexible enough to sand around curves and in corners, these sponges provide the comfort and control of a sanding block.

A layer of mesh lets sanding dust and debris escape during use, preventing material buildup on the abrasive surface. These sheets resist deterioration when used wet or with grease, chemicals, cutting fluids, and other solvents that may be present when sanding.

Providing the control of a sanding block while remaining flexible, these sponges sand around curves and in corners.

Use these rolls to create consistent finishes on hard metals such as stainless steel, iron, and nickel.

Create consistent finishes on stainless steel, titanium, steel, iron, and nickel.

Cut to convenient sizes and shapes, these fit most sheet sanders.

Peel and stick to your file handle. When it’s time to change the sheet, peel it off.

A coating prevents dust and debris from building up on the abrasive surface.

Use these sheets with an oscillating tool—their triangular shape reaches into tight corners and spaces. With hook and loop backing you can quickly attach, remove, and reuse them with a compatible backup pad.

Quickly attach, remove, and reuse these hook-and-loop sheets with pole sanders.

A coating prevents dust and debris from building up on the abrasive surface.

The premium abrasive stays sharp longer.

The ceramic alumina abrasive on these discs is sharp and dense enough to shape hard metals such as stainless steel, nickel, and cast iron without dulling quickly.

Coated with either ceramic alumina or a premium form of aluminum oxide, these discs last longer, cut faster, and produce a more consistent finish than standard hook and loop discs.

Quickly attach, remove, and reuse these discs with a compatible sanding tool or backup pad.

These discs have multiple layers of brick-shaped abrasive arranged in a pattern to create highly consistent finishes.

The abrasive material on these discs is sharp and dense enough to shape hard metals such as stainless steel, nickel, and iron without dulling quickly.

These discs have a harder abrasive than standard quick-change discs.

These discs have a harder abrasive than standard flexible-edge quick-change discs.

These belts resist deterioration when used with water or cutting fluids.

Avoid clogs when you're removing paint or rust. The widely spaced grains on these belts give dust and debris a place to collect so they won't build up on the surface.

Use these narrow belts on hand-held sanding sticks.

Choose a bit with the same angle as your countersink to debur the inside of the hole.