We will reply to your message within an hour.
More
These screws are beveled under the head for use in countersunk holes.
18-8 stainless steel screws have good chemical resistance.
More corrosion resistant than 18-8 stainless steel screws, these have excellent resistance to chemicals and salt water.
Brass screws are corrosion resistant in wet environments and electrically conductive.
Beveled under the head for use in countersunk holes, these steel screws press threads into material for a tight, secure hold.
These steel screws are zinc plated to resist corrosion in wet environments.
With more points of contact than Phillips-, slotted-, and square-drive screws, you can firmly press these Torx-drive screws into wood without stripping them or damaging the recess—their threads create a tight hold.
A decorative rounded top provides a finished appearance. These Phillips screws are beveled under the head for use in countersunk holes. They press threads into material for a tight, secure hold.
These Phillips head screws have a decorative rounded top that provides a finished appearance.
With a low-profile rounded head that’s flanged to sit flush for a finished appearance, these screws press threads into wood on cabinets, trim, molding, and light duty framing.
Also known as Type 17 auger point screws, these penetrate hardwood and reduce driving torque. They require a pilot hole to prevent splitting when used near an edge.
These 316 stainless steel screws have excellent resistance to chemicals and salt water.
Screws are beveled under the head for use in countersunk holes.
Also known as deck screws, these Phillips screws have a sharp point and narrow body to penetrate softwood and plastic-wood composite decking material.
Because these steel screws cut threads into drilled holes as they’re turned, they require less driving torque and cause less stress on material than thread-forming screws. Also known as trim-head deck screws, they have a small flat head and slender shank to reduce the risk of splitting boards.
Thread-forming screws press threads into drilled holes for a tight, vibration-resistant assembly.
Hang drywall to wood framing. These screws have a sharp point that penetrates drywall and a curved neck that sinks in without tearing the paper surface.
Alternating high and low threads minimize driving torque and allow the screw to hold more material between threads for a stronger hold and better strip-resistance than standard drywall screws for wood.
Ribs under the head act as a brake to prevent over-tightening and damaging threads.
These studs are also known as hanger bolts—use them to hang, mount, and fasten parts to wood structures.
Turn these studs with a hex key for ease of installation.
Also known as round-head Type U drive screws.