Two clamps connected by a pivoting arm hold workpieces at nearly any angle.

Each arm has a handle for turning the magnets on and off.

Hold magnetic workpieces in place with these clamps.

Clamp up to three workpieces at 90° angles.

Mount these clamps to a bench top or other surface to keep workpieces in place.

Push the lever to lock the handle and prevent accidental opening.

The handle locks in a horizontal position for more clearance above the clamp than standard hold-down toggle clamps.

Push the lever to lock the handle and prevent accidental opening.

Reduce the chance of getting pinched when unclamping. These clamps have more space between the handle and the arm than other low-profile toggle clamps.

Weld these clamps to the side of an object or drill your own holes in the mounting plate and bolt into place.

Two sets of mounting holes allow mounting on the bottom or side.

The mounting base secures these clamps to a rail or bar.

Attach one of these nonmarring rubber or plastic tips to prevent a metal holding screw from damaging workpiece surfaces.

These clamps have mounting holes on the bottom.

The clamping arm slides freely along the bar for quick, one handed positioning. Tighten the screw onto a workpiece and the arm locks in place.

For the most demanding jobs, these clamps have almost five times the capacity of standard fast-action bar clamps.

Press the trigger to slide the clamping arm along the bar. Release the trigger and squeeze the pistol-grip handle to lock the clamp in place.

All adjustments can be made from one end, allowing clamping in tight spaces.

Pull the lever to slide the clamping arm along the bar; release to lock in place.

Attach to your bar clamp to hold material on three sides.

The large, flat jaws remain parallel when clamping to apply even pressure without denting or marring the workpiece. Pull the handle to lock or release the clamping arm.

Also known as J-clamps, these provide additional clearance to reach around obstructions and clamp workpieces in recessed areas.

Apply pressure to the side of a workpiece as well as the top and bottom.

Hold the workpiece down against a bench or table.

A bright finish makes these clamps easy to see.

Turn the handle to tighten these multipurpose tools for strong clamping in nearly any application.

These clamps have twice the capacity of standard C‐clamps.

All components of these clamps are made of aluminum-bronze that is Factory Mutual approved. They satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.

Made entirely of fiberglass, these clamps won’t transmit electricity and are chemical resistant. They're often used around electrical equipment as well as in plating and anodizing applications.

Three screws apply pressure to three sides of a workpiece.

Push or pull the plunger to hold your workpiece from the side.

Hold workpieces of different thicknesses without adjustment.

Smaller than standard push toggle clamps, these are often used for electronics and small fixturing applications.

The handle can be rotated 125° for easier access or extra clearance above the clamp.

Pull the handle backward to push the plunger forward. These clamps secure when the plunger is fully extended to hold your workpiece from the side.

Panel mount through a hole with the included nut, or drill and tap a hole to flush mount. A pushing or pulling motion holds workpieces from the side.

The open clamp design permits welding around almost the entire pipe circumference. A combination of chains and support bars hold a variety of pipe sizes.

Push the lever to lock the handle and prevent accidental opening.

Fit the draw arm over a latch plate and pull the handle to clamp.

Turn the knob to adjust the opening size.