Use these switches to turn motors on and off, or with lighting and electric heat circuits. They do not provide overload protection.

Safely turn motors on and off near ignitable gases and dust—the housing on these switches seals in anything that could ignite flammable material.

Start and stop motors outdoors and in other wet environments.

Use these switches with motors that run forward and backward, such as motors for conveyor belts.

The NEMA 4X rated enclosure protects these starters from corrosion and washdowns.

Provide on/off control for a motor and protect it from overloads. These starters shut the motor off if current exceeds the full-load current rating.

Use these starters with motors that run forward and backward, such as motors for conveyor belts.

Save electricity and extend motor life by reducing the motor's starting current.

Sealed coils protect these switches against moisture, heat, dirt, and mechanical and thermal stress.

Housed in a durable steel enclosure.

Mount these monitors to DIN rail.

Install these switches in a panel cutout.

Protected by a steel enclosure, these switches withstand tougher conditions than switches in a plastic housing. Also known as safety switches, they have quick-make/quick-break action to eliminate arcing and prolong switch life.

Cut power and keep it isolated to prevent equipment from starting up during inspection and maintenance. These switches are housed in a protective enclosure that resists denting, chipping, and cracking.

With a housing that’s designed to contain an explosion, these switches are safe to use in areas where ignitable concentrations of flammable or combustible gas, dust, or fibers may be present.

Keep power running while you access your enclosure. Unlike standard enclosure disconnect switches, which shut off power as you open your enclosure, these have an override function.

Unlike mechanical relays, these solid state relays have no moving parts, so they require less maintenance and last longer, switch faster, and are quieter. They mount on 35 mm DIN rail (also known as DIN 3) for fast installation.

Receive signals from safety monitoring relays or controllers to switch devices off and on because of a system failure.

Often used to regulate the speed of AC fans or keep a heater at a set temperature, these relays connect directly to sensors to calculate and adjust output power. This allows you to use an analog input without converting it to a digital signal to control output power.