Keep splicing connectors on hand for two, three, or five wires. Press down on the clamp to connect wires and pull it up to disconnect. The splicing connectors are clear, so you can see the connection. They have two test slots to check voltage after installation.

Designed for use in high-temperature applications such as motors, ovens, and furnaces, these assortments include a variety of terminals and splices made of heat-resistant materials. They are noninsulated, so you can easily inspect the wire connection. Use a crimper (not included) to install wire.

Keep on hand a variety of different sized terminals and splices with the most secure, sealed connection we offer. Heat the outside and the enclosed solder melts to secure your wire. The insulation also shrinks when heated, keeping out water and contaminants.

Ring, quick-disconnect, and spade terminals have insulation covering the barrel to prevent short circuiting with nearby wire. Butt splices have a fully insulated connection tab, so no metal is exposed when they’re mated.

For use where water and contaminants are a concern, the terminals and splices in these assortments have insulation that shrinks and creates a tight seal when heated. Use a crimping tool (included with some assortments) to install wire.

Barrel-insulated terminals have a plastic cover to prevent short-circuiting with nearby wire. Fully insulated terminals have a connection tab that’s completely covered, leaving no metal exposed when mated.

Nylon/polyolefin insulation is more durable than polyolefin insulation.

Keep a variety of lug sizes on hand. Either solder these lugs into place, or use a hammer-on crimper (not included) for a secure connection.

Keep on hand the set screw lugs, nuts, and bolts needed to install single- or three-phase dry-type transformers. Tighten the set screw onto your wire for a secure connection without crimping.