Plug in the thermostat, then plug your heater into the socket on the thermostat's plug.

Control one- and two-speed heaters and air conditioners.

Set these thermostats to adjust the temperature at certain times each day. They regulate heaters that use direct electrical power, such as baseboard and wall heaters.

Commonly used with hydronic heaters, this thermostat senses the temperature of liquids. The thermowell protects the sensor.

Use to regulate line-voltage HVAC systems where flammable gases, vapors, and dust are present. Thermostats are rated Class I, Divisions 1 and 2, Groups C and D; and Class II, Divisions 1 and 2, Groups E, F, and G.

Keep electronics in your enclosure from getting too hot or cold with these thermostats that control two devices at once.

Also known as snap discs, these thermostats switch on cooling systems or switch off heating systems when equipment gets too hot.

Set these thermostats to adjust the temperature at certain times each day.

If ambient air temperature rises above or falls below an actuation point, this thermostat flashes the current temperature reading on the display and shows a “high” or “low” message.

Set to actuate at a specific temperature, these switches are easy to setup and prevent changes to the setpoint. They have a threaded probe, so they install directly into tanks, pipelines, and other process components to turn equipment on and off at a set temperature.

Install the threaded probe directly into tanks, pipelines, and other process components to turn heating equipment on or off at a specified temperature.

Often used in hazardous locations, such as chemical plants, refineries, and grain elevators, these switches have a housing that’s UL listed for environments with flammable gases, combustible dust, and ignitable fibers.

To protect these switches from splashing water, corrosive liquid, and dust, the housing meets NEMA 4X for washdown conditions.

Safe for use in chemical plants, refineries, and other hazardous locations, these switches maintain your surface’s temperature by turning equipment on or off when they reach a set temperature. They’re FM approved for use where flammable gases may be present.

Install directly into drilled and reamed holes.

An adjustable reset lets you control the amount of temperature change, also known as deadband and differential, before these switches reset. When they reach the set temperature, they send an electronic signal to your programmable logic controller (PLC) to turn equipment on or off.

The faceplate on these controllers is sealed to meet NEMA 4X and IP66 for protection in washdown environments with splashing water, corrosive liquid, and dust.

For protection in washdown conditions with splashing water, corrosive liquid, and dust, these controllers have a wall-mount housing that meets NEMA 4X. They’re ideal for systems with rapid, unpredictable, or complex temperature changes.

Mount these temperature controllers directly onto DIN rail for controlling systems with rapid, unpredictable, or complex temperature changes. They turn heating equipment on and off using a proportional-integral-derivative (PID) control algorithm to make fine adjustments, giving you the most precise and stable temperature control.

The simplest temperature controllers—they turn devices fully on or off, with no middle state, at a given temperature.

Switch heaters on or off when your process reaches a certain temperature. Both these controllers and your heater will be powered by the same wall outlet.