Reduce the chance of getting pinched when unclamping. These clamps have more space between the handle and the arm than other low-profile toggle clamps.

Hold workpieces of different thicknesses without adjustment.

A highly durable construction with hardened steel pivot pins and bushings provides a long service life.

Hold workpieces of slightly different thicknesses with one clamp. These clamps automatically adjust to compensate for imperfections or small inconsistencies on the material’s surface.

A nonreflective black oxide finish prevents glare that can interfere with machine vision systems.

Often used when assembling small parts, these small clamps have the holding strength of a full-size clamp.

Weld these clamps to the side of an object or drill your own holes in the mounting plate and bolt into place.

Two sets of mounting holes allow mounting on the bottom or side.

The mounting base secures these clamps to a rail or bar.

Attach one of these nonmarring rubber or plastic tips to prevent a metal holding screw from damaging workpiece surfaces.

These clamps have mounting holes on the bottom.

Mount the base to a work surface using screws.

Mount to the top of your workbench.

Push or pull the plunger to hold your workpiece from the side.

Pull the handle backward to push the plunger forward. These clamps secure when the plunger is fully extended to hold your workpiece from the side.

The handle can be rotated 125° for easier access or extra clearance above the clamp.

Moving parts are protected by a metal cover when the clamp is engaged to prevent dirt and dust from clogging the clamp.

Smaller than standard push toggle clamps, these are often used for electronics and small fixturing applications.

Panel mount through a hole with the included nut, or drill and tap a hole to flush mount. A pushing or pulling motion holds workpieces from the side.

Each arm has a handle for turning the magnets on and off.

Sized for small parts and tight spaces, these clamps have a pivoting pad at each end to hold workpieces at any angle up to 180°.

Clamp workpieces from the outside at a 90° angle, leaving the inside free for welding or fabrication.

Secure a workpiece from the inside, leaving the outside clear for machining.

Build these components into fixture plates, machine subplates, and tombstones for quick changes. The system clamps and locates at the same time for accurate positioning with repeatability of ±0.0005".

Mount using the holes in the base.

Screw these clamps directly into a tapped hole in a fixture.

Machine these clamps to match the contours of your workpiece and turn the screw to grip.

Unlike the smooth and flat edges of standard fixture clamps, these clamps have ridges that bite into parts, making them good for gripping castings and rough-cut stock.

Use these blocks to support setup clamps. Fit the nonslip steps together for quick height adjustments.

Eliminating the need for step blocks or other rear support, the pivoting rocker clamps workpieces of various thicknesses.

The stepped end provides support and quick height adjustment when paired with a step block.

A plastic pad on the gripping surface of these clamps prevents workpiece marring, making them useful for holding polished surfaces and reducing the need for secondary finishing steps.

Making minimal contact with the workpiece while holding securely, these clamps are good for small parts and can clamp into holes and notches.

Position these clamps between two workpieces, vises, or fixtures and secure both to your machine table using T-slot nuts or bolts.

Get everything needed for basic workholding on a machine table.

Use these clamps to hold large round parts for machining. Each clamp comes with five lengths of chain that combine to accommodate different size workpieces.

The built-in T-slot nut on these side clamps lets you clamp a part to a machine table quickly. Their small footprint leaves more free space on your table than standard side clamps.

Fit the draw arm over a latch plate and pull the handle to clamp.

A highly durable construction with hardened steel pivot pins and bushings provides a long service life.

Clamp up to three workpieces at 90° angles.