A rubber seal protects these switches from splashing water.

Maximize the space in a panel—these switches are half the size of most toggle switches.

Able to withstand high currents, these switches are often used with motors and pumps.

Sized for 4 mm or 6 mm panel cutouts, these switches are often used with circuit boards to control electronics.

Choose from a variety of messages and colored lenses to combine a rocker with a base and wiring socket for a complete switch.

Also known as high-inrush current switches, these switches can handle starting currents up to 10 times greater than their rating, such as when a motor starts.

Keep your hands free for other tasks by triggering switches with your foot.

Step on these switches for hands-free actuation in an area with frequent washdowns.

Like turning on a flashlight, slide these switches from one side to the other.

Immediately cut power by pulling the cable.

Rated NEMA 6P, 13, and IP67, these switches are protected from corrosion, oil/coolant spraying, washdowns, and temporary submersion.

Using a low-current signal, these relays are often used to control small motors and heaters.

The circular pin terminals plug into relay sockets for easy installation.

Sealed for safety, these relays are a good choice for hazardous locations where combustible or corrosive gases may be present.

Reduce connection errors on circuit boards that control machine guards and other safety devices. These relays take up less space on a board than those with electrical wiring because their solder pin terminals mount directly through circuit board holes.

Split run time between two devices—these relays automatically alternate between them.

Install these relays in a panel cutout or plug them into a relay socket. Unlike mechanical relays, these solid state relays have no moving parts, so they require less maintenance and last longer, are quieter, and switch faster.

Get a variety of timing functions in a single relay.