The lever sticks out further than a push button, making it easy to identify the position of these switches. They're often used in marine environments.

Switches with a sealed body provide extra protection from moisture and dirt.

Three-position switches close one contact when pulled to the middle position, and close two contacts when pulled all the way.

For technical drawings and 3-D models, click on a part number.

Install these switches in a panel cutout to automatically turn electrical equipment on or off after a set interval.

Switches with set time recall retain the last setting; push the button to start the timer over at the same interval, eliminating the need to reset the dial with every use.

Install these switches in a panel cutout. Small enough to fit in tight spaces, they handle comparable electrical loads to standard sized switches. They cut power and keep it isolated to prevent equipment from starting up during inspection and maintenance. All have a lockout so you can secure them in the off position with a padlock (not included). They’re rated IP65 for protection from washdowns.

For technical drawings and 3-D models, click on a part number.

Install these switches in a panel cutout. They cut power and keep it isolated to prevent equipment from starting up during inspection and maintenance. All are UL listed, C-UL listed, and CE marked—they meet American, Canadian, and European safety standards.

Switches with lockout secure in the off position with a padlock with a maximum shackle diameter of 5/16” (not included).

Add auxiliary contact blocks to send a signal or connect to another device, such as an alarm or indicating light.

Use additional power poles to control more than three circuits. Add neutral poles to open and close the neutral leg of a three phase system.

Terminal covers prevent contact with live terminals.

For technical drawings and 3-D models, click on a part number.

Manually control these valves by pushing or turning the actuator. Also known as 3-way or 3/2 valves, they create one action, such as extending a cylinder. They direct airflow from the inlet to your equipment and exhaust return airflow to create motion. In the off position, they exhaust air pressure from the system, allowing equipment to reset so the action can be repeated.

Normally closed valves block airflow until actuated.

Valves with hand return actuation stay actuated and go back to their starting position only when you move the actuator again.

Flow coefficient (Cv) is a measurement that indicates how much airflow can pass through a valve. When selecting between valves with the same port size, choose the valve with the higher flow coefficient to ensure it provides enough airflow to operate your system.

For technical drawings and 3-D models, click on a part number.