These switches meet MIL-S-3950.

Prevent accidental actuation—these toggle switches must be pulled up before they can switch a circuit.

Because these switches mount flush against a panel, they're easy to clean and hard to damage.

Install in 16 mm dia. cutouts.

Install in 12 mm dia. cutouts.

Install in 10 mm dia. cutouts.

Choose from a variety of messages and colored lenses to combine a rocker with a base and wiring socket for a complete switch.

Also known as high-inrush current switches, these switches can handle starting currents up to 10 times greater than their rating, such as when a motor starts.

Rated IP67, these switches are protected from temporary submersion.

Apply pressure from any direction to actuate these switches.

Step on these switches for hands-free actuation in an area with frequent washdowns.

When the pedal is pressed, the built-in potentiometer adjusts the resistance to vary the speed for motor drives.

Install these key switches in 3/4" dia. panel cutouts. They require a key to turn circuits on or off, limiting access to sensitive equipment.

Reset fire panels, or open electromagnetic locks, electric strikes, and automatic door openers. These switches require a key to turn circuits on or off, limiting access and preventing accidental activation.

Immediately cut power by pulling the cable.

Open and close circuits quickly to minimize arcing and prevent contacts from sticking. These switches are often used as door-open indicators on appliances and enclosures.

Enclosures protect these snap-acting switches from the environment.

Built for tight spaces exposed to water, these switches have a housing that's less than 1" long and IP67 rated for protection from temporary submersion.

Smaller than standard size snap-acting switches, these fit in tight spaces.

Often used in large, open workspaces, these switches can be wired on opposite ends of the room to control lights on the same circuit. They're also known as three-way and four-way switches.

Also known as three-way switches, these are often used in large, open workspaces and can be wired on opposite ends of the room to control lights on the same circuit.

Vary electrical flow to control speed, volume, and light intensity. Also known as variable output switches.

Mount these Ethernet switches to DIN rail to bring connections closer to where you need them.

Also known as an air-to-electric switch, this relay converts an air signal to an electric signal.

With a round body that’s at least one-third thinner than traditional pressure switches, these fit in tight, cramped spaces.

The traditional pressure switch. These power equipment, activate controls or alarms, or kick-off other actions when they reach a set pressure.

Kick off automated controls, signal alarms, or activate equipment based on pressure changes while checking the pressure, setpoint, and reset point on the display.

With an explosion-proof enclosure that meets NEMA 7 and 9 standards for hazardous locations, these switches were tested and verified by UL and CSA for use where explosive gas or dust may be present. Often used with ovens, dryers, and HVAC systems, they can indicate a filter is clogged or help maintain a certain air pressure.

Tested and verified by UL and C-UL for use where explosive dust or gas are present, these switches have an explosion-proof enclosure that meets NEMA 7 and 9 standards for hazardous locations. They are often used to indicate a filter is clogged in a pump or cooling system.

Often built into pumps and hydraulic systems with limited space, these compact switches power equipment, activate controls, and signal alarms when they reach a set vacuum.

Prevent changes to the set vacuum that powers equipment, activates controls, or signals alarms. The setpoint on these switches isn't adjustable.