These switches meet MIL-S-3950.

Prevent accidental actuation—these toggle switches must be pulled up before they can switch a circuit.

Snap these switches onto your DIN rail to mount them. With a toggle switch and receptacle combined, you can actuate power and plug in devices from a single box.

Because these switches mount flush against a panel, they're easy to clean and hard to damage.

Actuate these switches with a quick push. A housing seals in anything that could ignite flammable material, so you can use them where ignitable gas and dust may be present.

Because these switches mount flush against a panel, they're easy to clean and hard to damage.

Because these switches mount flush against a panel, they're easy to clean and hard to damage.

Install in 8 mm dia. cutouts.

Save space in your setup—these switches double as handles on machines and equipment.

Choose from a variety of messages and colored lenses to combine a rocker with a base and wiring socket for a complete switch.

Also known as high-inrush current switches, these switches can handle starting currents up to 10 times greater than their rating, such as when a motor starts.

Rated IP67, these switches are protected from temporary submersion.

Apply pressure from any direction to actuate these switches.

Step on these switches for hands-free actuation in an area with frequent washdowns.

When the pedal is pressed, the built-in potentiometer adjusts the resistance to vary the speed for motor drives.

Rated NEMA 4 or IP66, these switches are protected from washdowns.

Alternate between two batteries without interrupting power.

Connect these switches to a cable to control circuits from a distance. They're typically used to turn off production lines and material handling systems.

Open and close circuits in a snap. These switches actuate quickly to minimize arcing and prevent contacts from sticking.

Enclosures protect these snap-acting switches from the environment.

At least 25% smaller than our Miniature Snap-Acting Switches, these switches are often used to trigger actions from inside a vehicle’s door or an engine compartment.

Smaller than standard size snap-acting switches, these fit in tight spaces.

Start or stop equipment after a set number of rotations to avoid over-rotation.

Often used in large, open workspaces, these switches can be wired on opposite ends of the room to control lights on the same circuit. They're also known as three-way and four-way switches.

Also known as three-way switches, these are often used in large, open workspaces and can be wired on opposite ends of the room to control lights on the same circuit.

Vary electrical flow to control speed, volume, and light intensity. Also known as variable output switches.

Suitable for DC-powered equipment such as forklifts, floor scrubbers, and trucks.

Mount these Ethernet switches to DIN rail to bring connections closer to where you need them.

With a round body that’s at least one-third thinner than traditional pressure switches, these fit in tight, cramped spaces.

Prevent changes to the set pressure that activates equipment—these switches come ready to use at your preferred setpoint.

Used as a safety control, these switches must be manually reset each time they hit the set pressure, so you can inspect equipment before it restarts.

With an explosion-proof enclosure that meets NEMA 7 and 9 standards for hazardous locations, these switches were tested and verified by UL and CSA for use where explosive gas or dust may be present. Often used with ovens, dryers, and HVAC systems, they can indicate a filter is clogged or help maintain a certain air pressure.

Tested and verified by UL and C-UL for use where explosive dust or gas are present, these switches have an explosion-proof enclosure that meets NEMA 7 and 9 standards for hazardous locations. They are often used to indicate a filter is clogged in a pump or cooling system.

Often built into pumps and hydraulic systems with limited space, these compact switches power equipment, activate controls, and signal alarms when they reach a set vacuum.

The traditional vacuum switch. When these switches reach a set vacuum, they power equipment, signal controls, or trigger alarms.