Secure circuit breaker switches that don’t have a hole for a padlock.

Suitable for most major multipole breakers that have a tie bar, including GE, ITE, Sylvania, Challenger, Bryant, Westinghouse, Square D, and General Switch Co.

Use the push-button end to easily install this lockout on circuit breakers with pin lockout holes on the outside of the circuit-breaker toggle switch that are mounted on DIN rails.

Use the push-button end to easily install these lockouts on circuit breakers with pin lockout holes on the inside of the circuit-breaker toggle switch that are mounted on DIN rails.

Lock out a machine with fewer padlocks when a team is working.

Same as our other low-profile lockout hasps, but with an attached label to record employee name and department.

Made entirely from nonconductive plastic for excellent electrical insulation.

Like two lockout hasps in one, there's a jaw at each end with different clearances for added versatility.

With a smaller overall length, these lockout hasps fit in tighter spaces than other lockout hasps yet still hold a similar number of locks.

In addition to an overlapping hasp that interlocks when closed, lockouts have a chain that attaches to equipment so they won't get lost.

The overlapping hasp interlocks when closed for added security.

Extend the cable and place its loop in the body opening. Rotate the body to lock the cable for a secure fit. When unlocked, the cable retracts into the body with the push of a button.

After locking, pull the cable tight for a secure fit.