Stick these flexible heat sheets to container surfaces to warm contents without direct contact.

Less than 0.015″ thick and highly conformable, these heat sheets warm components in tight spaces within complex designs.

Also known as foil heaters, these bend around corners and edges without causing damage to the heating element.

Keep gas flowing even when the temperature drops—also known as heat blankets, these heaters wrap around propane tanks to safely warm liquefied gas so it can vaporize.

Nonstandard-size containers are no problem—use the hook-and-loop closure to adjust these heaters to fit a range of diameters.

Strap these heaters around cylinders to keep gas flowing when the temperature drops. Also known as heat blankets, they heat cylinders from the outside, safely warming liquefied gas enough so that it can vaporize.

These ETL-listed heaters keep containers warm in areas where hazardous material is present. Also known as heat blankets, they surround drums and totes to heat them up quickly.

To prevent hot spots that can damage heat-sensitive materials such as adhesives, sealants, and food, these heaters warm the air around containers without touching them.

Place your drum right on top of these heaters to start heating.

To prevent moisture damage, these heaters have a seamless 304 stainless steel sheath.

When the ambient temperature changes, these heaters automatically adjust the heat output along the length of their cable. Also known as self-regulating heat cable, they don’t require a separate temperature switch or controller.

Turn the dial to control the percentage of time that these heaters cycle on, from 5% to 100%. Commonly used to thaw pipes, prevent valves from freezing, and heat beakers and flasks in labs, they're good for temporary and occasional use where rapid heating is required but precise temperature control is not.

Rated for a maximum heat output of 900° F, these heaters are often used for thawing frozen pipes and rapid spot heating.

With a cable that supplies the same wattage along the entire length, these heaters remain consistent regardless of the surrounding temperature. All require a temperature switch or controller to regulate heat output.

Keep the liquid inside your hose from freezing, maintain your liquid’s viscosity, and prevent condensation in chilly environments.

Often used with extrusion, injection, and blow-molding machinery, these heaters clamp around nozzles to keep material warm for consistent discharge.

Keep your battery running at full power even when the temperature drops—these heaters warm batteries quickly without overheating them.

Heat PVC conduit and pipe, then manually bend it to your desired angle.