We will reply to your message within an hour.
These clamps must be oriented with the saddle on the long (live) end and the U-bolt on the short (dead) end. They’re also known as wire rope clips.
Constructed with a saddle for both the long (live) end and the short (dead) end, these clamps apply equal pressure without crimping or crushing the wire rope, so orientation doesn't matter. Also known as fist grip wire rope clips.
Install these clamps without any specific orientation, slide the nut over the rope and tighten it onto the threaded halves with a torque wrench.
Make a removable loop without specialty tools for use in noncritical applications, such as fencing. Also known as tiller clamps.
A clamp and thimble in one convenient fitting simplifies installation while providing support and fray protection to the wire rope loop. Use a torque wrench to tighten the clamp.
These compression sleeves are designed to meet lifting specifications.
Use these sleeves for non-lifting applications such as tethering, securing, and suspending.
These kits include two compression sleeves paired with two thimbles. The thimbles support the wire rope loops and prevent it from fraying.
Also known as heavy-pattern thimbles, these can be used to reinforce the loop of a sling.
Also known as standard-pattern thimbles, these provide better protection against fraying than light duty thimbles.
These thimbles are also known as thin pattern thimbles.
The open-end design leaves more room for connections than other thimbles.
Install these stud-end plug-lock fittings on the end of wire rope for a strong hold and finished appearance.
Install these clevis-end plug-lock fittings on the end of wire rope for a strong hold and finished appearance.
Install these eye-end plug-lock fittings on the end of wire rope for a strong hold and finished appearance.
Install these swivel-hook-end plug-lock fittings on the end of wire rope for a strong hold and finished appearance.
Also known as open wedge sockets, these end fittings require only a torque wrench to install.
Attach these clamps by running a wire rope through the jaws to create an attachment point anywhere along the wire rope.
Tighten these jam nuts against the turnbuckle body to prevent the fitting from loosening.
Pull wire and cable while maintaining tension until the line can be permanently anchored. Use these clamps with stranded bare steel wire and cable.