These 18-8 stainless steel screws have a hardened steel drill point to penetrate steel and are coated to increase corrosion resistance.

These screws have the strength of 410 stainless steel with added corrosion resistance.

These steel screws are zinc plated to resist corrosion in wet environments.

18-8 stainless steel screws have good chemical resistance.

By drilling their own holes and fastening in a single operation, these square-drive screws save time and effort. Made of 410 stainless steel, they're both stronger and more wear resistant than 18-8 stainless steel screws.

A tamper-resistant Torx driver is required for installation and removal. Also known as pin-in-Torx, these screws allow you to apply extra force with less slippage or damage to the recess.

Made from stainless steel, these screws are more corrosion resistant than steel, and almost as strong.

With a drilling tip, these metric screws cut their own pilot hole and threads as you fasten them into material.

A tamper-resistant Torx driver is required for installation and removal. Also known as pin-in-Torx, these screws allow you to apply extra force with less slippage or damage to the recess.

Known for their strength, these alloy steel screws are coated to provide corrosion resistance in wet environments.

Beveled under the head for use in countersunk holes.

These steel screws have a head encapsulated by 18-8 stainless steel.

These screws have a free-rotating, permanently attached washer that remains stationary while tightening to prevent bunching while attaching tarps and other fabric to metal.

Also known as roofing screws, these screws are long and made from hardened steel to fasten rigid insulation board to steel decking.

18-8 stainless steel screws have good chemical resistance.

Also known as Type 17 auger point screws, these penetrate hardwood and reduce driving torque. They require a pilot hole to prevent splitting when used near an edge.

Power through drywall and into metal studs up to 0.105" thick.

These square-drive screws have a drill point that powers through drywall and into metal studs up to 0.105" thick. Heads are one-third smaller than those of other drywall screws.