This material has tighter tolerances than standard 303 stainless steel.

Hardened for improved strength and wear resistance, these rods are precision ground to a strict diameter tolerance. Use them for turning applications in your lathe.

Also known as Project 70+, this material machines faster with less wear on cutting tools than standard 17-4 PH stainless steel.

Hardened for superior wear resistance, these rods are precision ground to a tight diameter tolerance so they’re ready for turning in a lathe.

With a diameter that’s held to a close tolerance, this material is hardened for increased wear and abrasion resistance.

Combine these general purpose shafts with a linear bearing and shaft support to create a basic linear motion system.

Made with two pieces, these shaft supports secure your shaft parallel to your mounting surface and make it easy to access the shaft without having to slide it out or uninstall the support. Use these supports when working with light to medium loads where shaft alignment is not critical.

Replace worn shafts in two-piece support-rail shaft systems, or mate with a support rail to create your own. The tapped mounting holes match those on our Support Rails.

Combine these general purpose drive shafts with gears, sprockets, and bearings to transmit rotary motion.

These shafts have keyways only on the ends, leaving a plain shaft in the center. Use the keyways with machine keys to transmit torque to gears, sprockets, and other keyed components. Use the middle of the shaft with bearings and other round-bore components.

The diameter of these shafts is slightly smaller than listed, so precision ball bearings (ABEC-3 and above) slide on without any tools.