We will reply to your message within an hour.
A ratchet mechanism allows you to turn fasteners without removing and repositioning the wrench.
The handle is covered in rubber for a comfortable grip.
When the ratchet head becomes worn or damaged, change it out for a new one.
No need to pull the socket off the tool—push a button to release.
The shaft on these wrenches extends and locks.
A gasket seals in permanent lubrication and keeps out dirt, dust, and moisture.
Twist the grip to rapidly turn a socket before final tightening or to remove a fastener once loosened. The handle also swings like a traditional ratchet wrench.
Also known as a construction or spud handle, wrenches use the pointed end to align bolt holes.
Insulated to protect against accidental contact with live electrical circuits, these wrenches are tested to 1,000 volts to meet IEC 60900.
Made of aluminum-bronze, these wrenches satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.
Pivot the head to access fasteners in tight spots.
The 20° offset head provides clearance when reaching over obstructions.
Rather than teeth, these wrenches use a series of rollers to engage the ratchet, enabling work in the tightest of spaces. Also known as silent ratchets, they don't make the traditional click sound when turned.
Turn sockets in the most confined spaces.
Pivot the head for access to fasteners in tight spots.
The ratcheting mechanism turns sockets quickly.
Set the desired torque and the wrench indicates when it's reached with an audible click and an impulse in the grip.
Unlike most torque wrenches, you don’t have to return the torque setting to the lowest value after use. These tools are also known as split-beam torque wrenches.
Made of beryllium copper, these wrenches satisfy OSHA requirements that specify nonsparking tools for locations where flammable vapors and combustible residues are present.
Turn sockets from above when there's not room to swing a standard wrench handle.
These wrenches have an accuracy of ±2.0%.
Measure with an accuracy of ±2%.
Trust the precision of your measurements—these wrenches are accurate to ±1%.
These wrenches slip to disengage and stop turning the fastener when the set torque is reached, preventing overtightening.
The most advanced torque wrenches we offer, these tools store and recall up to 1,500 torque and angle measurements.
When the set torque is reached, these wrenches signal with an audible click and an impulse in the grip.
Use these tools for general shop applications.
Built for durability, these wrenches handle the demands of high-volume production and tough maintenance applications.
Grip the indentations around the outside of tri-groove fasteners.
Quickly position these sockets on square and external 8-point fasteners.
Safely extend your reach in areas where you could accidentally come into contact with live circuits.
Also known as E-style rings.
Also known as poodle rings, these thick rings have "ears" that form a large retaining surface to withstand stronger forces than other side-mount retaining rings.
Also known as flat-style speed nuts, these have a large surface to distribute loads better than standard and flanged external push rings.
No groove required—press these rings onto the end of a shaft for a firm grip.
Use these caps to hold components in place and protect shaft ends.
Slide these rings into place with one twist—no tools required—for applications with high thrust loads.
No groove required—these rings have teeth that firmly grip the bore.
Slide these rings into place by hand with a single twist for applications with high thrust loads.
Also known as key rings, twist these rings into place to secure clevis pins, connect components, or add a pull handle. They don't have the sharp ends of other cotter pins.
Also known as E-Style and C-style rings, slide these into the groove from the side of the shaft. They provide a wider shoulder than other external retaining rings for a larger retaining surface.
Also known as flat-style speed nuts, these have large sides, so they're easy to push over threads by hand.
Loop these rings onto tags.