Use where flammable gases, vapors, and dust are present in shops, garages, and warehouses—these heaters meet NEC Class I, Divisions 1 and 2, Groups C and D; and Class II, Divisions 1 and 2, Groups E, F, and G. Adjust the louvers to direct airflow. Mount on the wall with the included bracket.

All have a built-in thermostat.

The wiring compartment is sealed to NEMA 4 standards for protection from dust and washdowns. These heaters warm large areas such as shops, garages, and warehouses. Adjust the louvers to direct airflow. Mount on the ceiling or wall with the included brackets.

When operating the 208V AC/240V AC heaters at 208 volts AC, maximum area heated, and heat output are reduced by 25%.

Carry these heaters to offices, workstations, and other small spaces. All have a built-in thermostat.

19,100 Btu/hr. heater has a bracket you can use as a stand or to mount to the wall or ceiling. When operating at 208 volts AC, maximum area heated and heat output are reduced by 25%.

Often installed below windows, the low profile design keeps these heaters out of the way. They use convection to circulate warm air.

The housing has indentations to punch your own mounting holes.

When operating the 208V AC/240V AC heaters at 208 volts AC, maximum area heated and heat output are reduced by 25%.

Heater-mount thermostats are sold separately.

Also known as toe kick or kick space heaters, these heaters are designed to recess mount under counters and cabinets. Use in offices and other small spaces. The thermostat is included.

When operating the 208V AC/240V AC heater at 208 volts AC, maximum area heated and heat output are reduced by 25%.

Save floor space when heating offices, workstations, and other small spaces. These heaters have a built-in thermostat and recess mount into a wall. Optional mounting frames (sold separately) allow you to surface mount the heater.

When operating dual-voltage heaters at the lower voltage, maximum area heated and heat output are reduced by 25%.

Use where flammable gases and vapors are present—these heaters meet NEC Class I, Divisions 1 and 2, Groups C and D. They use convection to circulate warm air in small spaces. All have a built-in thermostat.

Stay warm at a desk, counter, or table. The housings for these heaters maintain a low temperature, so they’re safe to touch and minimize heat damage to surfaces if the heater tips over. These heaters will also automatically shut off if they tip over or overheat.

Control them with the on-off switch or a thermostat. Wall-mount/freestanding heaters have a built-in floor stand and can mount under desks. You can add an optional thermostat (sold separately).

Install near loading docks and other drafty areas to warm people and objects.

Ceiling/wall-mount heaters have a stainless steel grille and heating element to resist corrosion in pump houses and other moist locations. All have a built-in thermostat.

Use these powerful heaters to warm people in large spaces, such as warehouses. They have a safety shut-off that cuts the gas supply if the flame goes out. They include a wall-mount thermostat.