We will reply to your message within an hour.
Also known as toe clamps, these grip the side of a workpiece to leave the top free for machining.
The built-in T-slot nut on these side clamps lets you clamp a part to a machine table quickly. Their small footprint leaves more free space on your table than standard side clamps.
Use these blocks to support setup clamps. Fit the nonslip steps together for quick height adjustments.
Keep setup clamps from falling out of position when they are unclamped—the spring holds them up for quick workpiece insertion and removal. Also known as spring lifters.
Hold a workpiece securely from the side with minimal contact, leaving more of the workpiece free for machining.
Machine these clamps to match the contours of your workpiece and turn the screw to grip.
Unlike the smooth and flat edges of standard fixture clamps, these clamps have ridges that bite into parts, making them good for gripping castings and rough-cut stock.
Install these clamps into a slot in your fixture to grip at the bottom of a workpiece edge, giving the cutting tool maximum access.
Machine these fixture clamps to match the contours of your workpiece for a stronger grip.
Set one of these clamps between two workpieces in a fixture and tighten the screw to push the clamp's sides out for a secure hold.
Machine these fixture clamps to match the contours of your workpieces for a stronger grip. Place the clamp between the two workpieces in a fixture and tighten the screw to extend the sides of the clamp, creating a secure hold against both workpieces.
Push or pull the plunger to hold your workpiece from the side.
Smaller than standard push/pull toggle clamps, these are often used for electronics and small fixturing applications.
Hold workpieces of different thicknesses without adjustment.
A highly durable construction with hardened steel pivot pins and bushings provides a long service life.
Pull the handle backward to push the plunger forward. These clamps secure when the plunger is fully extended to hold your workpiece from the side.
Smaller than standard push toggle clamps, these are often used for electronics and small fixturing applications.
Secure your workpiece from the side by fully extending the plunger, and push a lever to lock the handle in place.
Moving parts are protected by a metal cover when the clamp is engaged to prevent dirt and dust from clogging the clamp.
The handle can be rotated 125° for easier access or extra clearance above the clamp.
Panel mount through a hole with the included nut, or drill and tap a hole to flush mount. A pushing or pulling motion holds workpieces from the side.
Push the lever to lock the handle and prevent accidental opening.
Secure these clamps to a rail or bar.
The plunger can be locked at any position along its travel.
Drill a hole to mount these clamps through a surface and secure the mounting flange with screws. The plunger can be locked at any position along its travel.
Use for repetitive clamping and in production environments or hard-to-reach locations.
The spring-loaded tips on these clamps swivel in all directions to make maximum contact with angled and uneven workpieces.
Also known as press screws, mount these clamps through a drilled hole and turn the crank to move the jaw end of the screw in and out.
When loosened, you can spin the body of this clamp around its mounting point for better access to the workpiece.
Attach to your bar clamp to hold material on three sides.
Three screws apply pressure to three sides of a workpiece.
Apply pressure to the side of a workpiece as well as the top and bottom.