The jaws have V-notches in 1/4" increments to measure the depth of bends.

Rounded jaws reduce damage to aluminum and other lightweight metal.

Turn your impact driver into a power crimper, and create raised edges on sheet metal more quickly than hand crimpers.

Reinforced construction lets these benders handle thicker material than bench-top benders.

Position the movable forming dies, also known as fingers, to make boxes, trays, and pans in different widths.

Make deep folds in roofing panels and other large pieces of sheet metal.

Pull and pinch metal extrusions, such as L-channels, so they fit precisely around contoured edges and frames.

Make bends up to 90° in metal sheets.

Bend wire and rod up to 1/2" diameter and flat stock up to 1/4"×1" with these rugged steel benders.

Create squares, coils, and S‐shapes.

This cutter has two blades that cut a 1/8" wide strip—peel it back for smooth edges with little distortion.

A double hinge provides high cutting force with low gripping pressure. These cutters are also known as aviation snips.

Make straight and curved cuts in sheet metal—these sets come with three tools for different cutting patterns. Also called aviation snips, they have a double hinge, so they cut with more force and require less effort to squeeze the handles than standard sheet metal cutters.

Blades are high-speed steel so they stay sharp longer than steel blades, and they can be sharpened.

Also known as bulldog snips, these have long handles and short blades for cutting through thick sheet metal with less effort than standard sheet metal cutters.

Blades are tapered to give you more control when cutting straight lines, tight curves, and circles, and they're serrated to prevent slipping. These cutters are also known as duckbill snips.

Made from aluminum bronze, the blade and handle on these cutters inhibit sparking and are FM approved. Use them for straight cuts.

Loosen a few screws to swap dull blades with new ones. These cutters have offset handles to keep your hands clear of the metal being cut.

Trim flush against a flat surface with the curved blades on these small scissors.

Short blades make these scissors easy to maneuver in cramped areas for small, detailed cuts less than an inch long.

S-shaped handles keep your hand clear of material, so you can cut flush against flat surfaces.

Cut and strip wire in tight spaces with the compact tips on these scissors.

For extra leverage to cut through Kevlar, metal, and plastics, these scissors have long handles and short blades.

Also known as electricians' shears, the back edge of the blade has a file to clean contacts.

Remove burs from both sides of sheet metal edges.

Triangular blades deburr the edges of small holes.

Smooth the edges of cut conduit and screw in fittings with a single hand tool.

Also known as machinist's scrapers, these tools remove material and smooth edges on a workpiece.