For accurate punching of inner and outer holes, these sets come with pilots that attach to the outer hole punch.

Slide thin sheets of material into the included die block then punch an inner and outer hole to create a shim or washer.

Quickly switch between inner and outer punches to create washers faster than with standard sets.

Strengthened edges cut holes up to 4" dia. in fabric, leather, rubber, and soft metal. Also known as arch punches.

Use these punches to make round holes up to 1" dia. in fabric, leather, and rubber.

Cut DIN-size holes in steel up to 7/64" thick using a driver ram and hydraulic pump.

Create holes for installing heavy duty industrial connectors. When the die and punch are pressed together, four centering mandrels in the die mark where to drill holes for the connector's assembly.

Create larger holes and make repeated punches with these drivers that supply 11 tons of force to the included hole punches.

The driver supplies eight tons of force to the hole punches in this set to make straight punches.

These punches are half the size of standard portable lever-operated punches. They come with punches and dies in varying sizes.

Deliver nearly three times the punching force of a standard portable lever-operated punch by holding one handle and turning the other 360°.

Our most powerful lever-operated punch, the rotary-action socket turns to deliver two to three times the punching force of other bench-mount lever-operated punches.

A throat depth more than double those of standard bench-mount lever-operated punches allows this tool to reach further past the edge of material.

Turn the handle of these punches while pushing down to punch holes in cork and rubber.

The body is cast steel.

Cut keyways at the edges of existing holes. Also known as a keyway nibbler.

A double blade creates two cuts and a 7/32" wide waste strip that peels back, leaving two smooth edges with little distortion.

Minimize material loss and edge distortion with these scissor-like cutters that cut metal up to 1/64" thick.

Also known as slotting shears, these cutters have a double blade that creates two cuts and a 7/32" wide waste strip that peels back, leaving two smooth edges with little distortion.

Convert your drill into a sheet metal cutter to make quick, low-effort cuts without a separate power tool.

This cutter has two blades that cut a 1/8" wide strip—peel it back for smooth edges with little distortion.

A double hinge provides high cutting force with low gripping pressure. These cutters are also known as aviation snips.

Blades are high-speed steel so they stay sharp longer than steel blades, and they can be sharpened.

Prevent waste from flying up as you work. A double blade makes two cuts to create a 7/64"-wide step that peels back, leaving little distortion and smooth edges.

Made from aluminum bronze, the blade and handle on these cutters inhibit sparking and are FM approved. Use them for straight cuts.

Also known as bulldog snips, these have long handles and short blades for cutting through thick sheet metal with less effort than standard sheet metal cutters.

Blades are tapered to give you more control when cutting straight lines, tight curves, and circles, and they're serrated to prevent slipping. These cutters are also known as duckbill snips.

Replace blades as they wear. These cutters are also known as tinners' snips.

Turn your workpiece while cutting to create curves and complex shapes.

Make straight, clean cuts in thick sheet metal.

Make long, straight cuts around your facility—these cutters have a 12" blade and are light enough to move from bench top to bench top.

Cut through spot welds on sheet metal and make faster, more precise cuts than drill bits and other hole saws.

The carbide teeth on these steel saws cut aluminum, brass, bronze, steel, and plastic sheets and last up to twice as long as high-speed steel teeth.

An extra-thick steel body with carbide teeth can cut through stainless steel structural framing and electrical enclosures.

Use these saws with a drill press to cut a variety of hole sizes in sheet metal.