A double hinge provides high cutting force with low gripping pressure. These cutters are also known as aviation snips.

Blades are high-speed steel so they stay sharp longer than steel blades, and they can be sharpened.

Snip tighter curves in smaller spaces than standard high-force cutters.

This cutter has two blades that cut a 1/8" wide strip—peel it back for smooth edges with little distortion.

Also known as tinners' snips, these cutters make straight cuts and curves.

Blades are tapered to give you more control when cutting straight lines, tight curves, and circles, and they're serrated to prevent slipping. These cutters are also known as duckbill snips.

Replace blades as they wear. These cutters are also known as tinners' snips.

Loosen a few screws to swap dull blades with new ones. These cutters have offset handles to keep your hands clear of the metal being cut.

Use to cut patterns in flat material with minimal material loss and less effort compared to manual cutters.

Punch small pieces out of material to create an almost burr-free cut with no material distortion.

Also known as slotting shears, these cutters have a double blade that creates two cuts and a 7/32" wide waste strip that peels back, leaving two smooth edges with little distortion.

Also known as scissor-blade shears, the bottom blade remains stationary while the upper blade moves up and down to cut metal up to 1/64" thick with minimal material loss and edge distortion.

Make long, straight cuts around your facility—these cutters have a 12" blade and are light enough to move from bench top to bench top.

Move these lightweight cutters wherever you need to make clean, straight cuts through metal.

Combine the cutting base and a corner punch to make rounded corners in sheet metal.

Cut armored cable such as BX, HCF, and MC and flexible metal conduit.

Minimize wire distortion when cutting 11/16" diameter and larger aluminum and copper power and communication cable.

Insulated handles protect against shock from accidental contact with live electrical circuits. These cutters are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

Insulated handles protect against shock from accidental contact with live electrical circuits. These cutters are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

Shaped like tweezers, these cutters make accurate, flush cuts in small wire without damaging the surface underneath. The grips drain static away from the tips, protecting sensitive components from electrostatic discharge (ESD).

Minimize material distortion while cutting steel and stainless steel wire rope.

Insulated handles protect against shock from accidental contact with live electrical circuits. These cutters are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.

An alternative to hacksaws and bandsaws, these cutters use leverage to cut rods cleanly in a single stroke.

Cut rods and bolts while leaving their threads intact.