These steel screws have corrosion-resistant finishes.

These 18-8 stainless steel screws have a hardened steel drill point to penetrate steel and are coated to increase corrosion resistance.

Cutting their own pilot hole and threads as you fasten them into material, these metric screws have a drilling tip.

These steel screws save you time and effort by drilling their own holes and fastening in a single operation.

A decorative rounded top provides a finished appearance.

Stronger and more wear resistant than 18-8 stainless steel, these screws are mildly chemical resistant.

Drill a pilot hole, cut threads, and fasten in one motion with these metric-threaded screws. Made of steel, they’re strong and wear resistant.

By drilling their own holes and fastening in a single operation, these square-drive screws save time and effort. Made of 410 stainless steel, they're both stronger and more wear resistant than 18-8 stainless steel screws.

A tamper-resistant Torx driver is required for installation and removal. Also known as pin-in-Torx, these screws allow you to apply extra force with less slippage or damage to the recess.

These steel screws are available with corrosion resistant finishes. A rubber-bonded washer compresses to form a watertight seal. They save you time and effort by drilling their own holes and fastening in a single operation.

Made from 410 stainless steel, these screws are strong, wear resistant, and mildly chemical resistant.

Made from 18-8 stainless steel, these screws have good chemical resistance.

Beveled under the head for use in countersunk holes.

These screws have a free-rotating, permanently attached washer that remains stationary while tightening to prevent bunching while attaching tarps and other fabric to metal.

These screws speed installation by drilling, tapping, and fastening wood and metal in a single operation.

A Torx drive has more points of contact than a Phillips drive, allowing you to apply extra force with less slippage or damage to the recess.

Power through drywall and into metal studs up to 0.105" thick.

A drill point powers through metal up to 0.105" thick.