3/8"-24 Screws | McMaster-Carr

Filter by

System of Measurement

Thread Size

Length

Threading

Fastener Head Type

Material

Finish

Thread Type

Fastener Strength Grade/Class

Thread Spacing

Drive Style

Socket Head Profile

Thread Direction

Head Height

Tensile Strength

Head Diameter

Drive Size

Head Width

Specifications Met

Shoulder Length

DFARS Compliance

REACH Compliance

RoHS Compliance

How can we improve?

1,038 Products

Fastening and Joining

Hex Head Screws

Hex Head Screws

Used with nuts to create a stronger joint than flat and rounded screws

Socket Head Screws

Socket Head Screws

With a deeper drive than flat and rounded head screws, these withstand more torque for a tighter hold

Flat Head Screws

Flat Head Screws

Fit in countersunk holes for a flush finish

Rounded Head Screws

Rounded Head Screws

Sit just above the surface for a low-profile finish and hold tighter than flat head screws

Set Screws

Exert pressure at the tip to hold parts in place, unlike screws that hold material together with threads

Shoulder Screws

Shoulder Screws

Rotate parts around the cylinder under the head to guide and align them during installation

12-Point Screws

12-Point Screws

12 contact points handle more torque than a hex head while a flange eliminates the need for a washer

T-Bolts

Turn by hand for easy fastening, use as a handle, or attach as a point for straps and clamps

Hanger Bolts

Suspend pipe and other fixtures with wire or cable ties

Thread Adapters

Thread Adapters

Join threads of a different type, size, and gender

Single-End Studs

Single-End Studs

Use the unthreaded end as a pivot point, hinge, shaft, or locator pin

Threaded Rods

Anchor, connect, or hang components in a wide variety of applications

Spring Plungers

Spring Plungers

Apply accurate, consistent pressure for positioning, indexing, and ejecting parts

Weld Nuts

Weld to metal surfaces to add permanent threads

Rivet Nuts

Add threads to thin panels with access from only one side; also known as blind inserts

Fabricating and Machining

Lathe Tool Insert Holder Replacement Parts

Lathe Tool Insert Holder Replacement Parts

Replace clamps, screws, shims, and other parts in lathe tool insert holders

Gear and Bearing Puller Forcing Screws

Gear and Bearing Puller Forcing Screws

Replace forcing screws on gear and bearing pullers

Building and Machinery Hardware

Knobs

Position, tighten, and secure fixtures and equipment

Power Transmission

Connecting Rods

Connecting Rods

Use with rod ends and swivel joints to link components in push/pull assemblies

Material Handling

Eyebolts

Route rope through the loop or attach hooks and shackles for lifting

Measuring and Inspecting

Transfer Punches

Transfer Punches

Mark the center of an existing hole onto a separate workpiece

The quick brown fox jumped over the lazy dog. Pedestal (35" Ht. x 4" Wd. x 4" Dp.)