We will reply to your message within an hour.
Also known as angle brackets.
A rubber seal protects against moisture around the installation hole.
Strengthen corners of cases and crates.
Connect wood 2×4s to posts and other flat surfaces.
Clamp these brackets to panel edges to quickly assemble crates.
Lock these brackets together with a pin or a bolt. They are often used on marine docks.
Machine holes and slots or weld in place.
These brackets come in one piece that can be cut-to-size with a hacksaw.
Interlock brackets to secure panels flush to flat surfaces.
A built-in level makes it easy to align panels.
Fit brackets together to assemble truck racks, gates, crates, and fences.
Often used in washrooms, these brackets mount panels and partitions.
The two-piece design accommodates a wide range of panel thicknesses.
Also known as roofing screws, these screws are long and made from hardened steel to fasten rigid insulation board to steel decking.
Steel washers provide a stronger bearing surface than plastic washers
Plastic washers resist moisture, chemicals, and friction and are good electrical insulators.
Add a flat mounting surface to a ball screw jack to support loads.
Add a flat mounting surface to to a screw jack to support loads.
Mount these boxes to the outside of an enclosure to access a programmable logic controller or other networked device without opening the enclosure.
Close off unused outlets.
Knockouts allow you to modify these boxes to fit your application.
With built-in threaded connections, these boxes allow you to attach conduit without using fittings.
Add depth to your switch box.
Close off unused switches.
Add depth to octagonal outlet boxes.
Add depth to your outlet box.
These boxes come ready to use with receptacles and/or light switches installed.
Mount these boxes on the surface of your wall in areas where you can't create a recess.
Use the built-in connections to attach conduit without using fittings.
These boxes have an open back to accommodate extra-deep low-voltage devices.
Designed for commercial use, these heavy duty boxes have thick, rigid walls.
These boxes come ready to use with receptacles installed.
Build your own outlet box or replace a damaged box.
Add depth to your weatherproof outlet box.
Rain, snow, and wet conditions won't damage these corrosion-resistant covers.
These corrosion-resistant boxes are built to withstand exposure to rain, snow, and wet conditions.
These corrosion-resistant covers can withstand rain, snow, and wet conditions without being damaged.
Exposure to rain, snow, and wet conditions won't damage these corrosion-resistant boxes.
Keep the cover closed during operation to completely shield the outlet and plug from rain, snow, and wet conditions.
Snap end and center sections together to create your own two-device or wider wall plate.
Close off unused switches and outlets.
Pair wall plates and adapters to create a custom cover for existing receptacles and switches to give them a rejuvenated look, no rewiring required.
Give switches and outlets a finished look.
Cover existing outlets and switches for a refreshed appearance, no rewiring necessary.
Keep switches and outlets under cover for protection from dust and dirt. These stainless steel plates resist corrosion and have a sealing gasket to keep out moisture.
A large angled opening provides an exit point for cords that run behind walls.
Create various data connector configurations by choosing adapters to snap into the ports in these wall plates.
Snap these wall plates onto flush-mount outlet strips to secure the outlet strip in a cutout.
For use with washdown receptacles, these outlet boxes withstand corrosive and washdown environments.
Mount electrical components along your strut channel to bring power to new locations.
Securely fasten strut channel to the floor.