Made with ceramic or coated with titanium nitride (TiN), the blades on these scissors stay sharp longer than uncoated stainless steel and steel blades.

Comfortably cut at any angle with these scissors. The blades rotate so your hand doesn’t have to.

Make clean cuts through duct tape and other sticky materials.

Longer handles and shorter blades give you more leverage than other scissors to cut tough materials such as leather, rope, and thick cardboard.

S-shaped handles keep your hand clear of material, so you can cut flush against flat surfaces.

With durable fine-point blades, these scissors make precise cuts even after repeated use.

The blades have narrow, sharp tips for precise trims and detailed cuts.

For extra leverage to cut through tough materials such as leather, rope, and thick cardboard, these scissors have long handles and short blades.

Prevent punctures while cutting with the ball-point tip.

Prevent snags and injury with the rounded points on these small scissors.

Trim flush against a flat surface with the curved blades on these small scissors.

Cut the ribbon at your grand opening or other milestone event.

Cut through the strong fibers of Kevlar.

Also known as tinners' snips, these cutters make straight cuts and curves.

Also known as bulldog snips, these have long handles and short blades for cutting through thick sheet metal with less effort than standard sheet metal cutters.

Handles are angled to keep your hand away from the material as you cut straight lines and curves.

Loosen a few screws to swap dull blades with new ones. These cutters have offset handles to keep your hands clear of the metal being cut.

Sized and shaped like pliers, these sheet metal cutters are small enough to fit in your tool belt.

Keep your hand away from the material being cut.

The handles are angled 90° from the blade so you can cut material from directly above tight spaces.

Make straight and curved cuts in sheet metal—these sets come with three tools for different cutting patterns. Also called aviation snips, they have a double hinge, so they cut with more force and require less effort to squeeze the handles than standard sheet metal cutters.

Prevent waste from flying up as you work. A double blade makes two cuts to create a 7/64"-wide step that peels back, leaving little distortion and smooth edges.

Also known as scissor-blade shears, the bottom blade remains stationary while the upper blade moves up and down to cut metal up to 1/64" thick with minimal material loss and edge distortion.

Prevent chipping, binding, and fracturing when cutting brittle, high-pressure laminated plastic.

Leave clean cut edges in a variety of pliable materials.

Cut straight lines and patterns with the rotary blades on this cutter.