These rolls are coated with aluminum oxide, which is the most common abrasive material and hard enough to sand steel and wood.

These rolls resist deterioration when used wet or with grease, chemicals, cutting fluids, and other solvents that may be present when sanding.

Quickly attach, remove, and reuse these hook-and-loop sheets with triangular detail sanders.

A coating prevents dust and debris from building up on the abrasive surface.

A special fastener on the back of these discs allows you to easily swap one disc for another.

Overlapping abrasive flaps bonded to a backing plate provide consistent material removal and even finishes.

These discs have a harder abrasive than standard flap sanding discs.

The flaps alternate between an abrasive to remove material and a lubricant that minimizes heat to reduce discoloration of the work surface.

Replace your sanding discs less often—the backing plate on these discs can be trimmed off as the abrasive flaps wear down, allowing you to use more of the disc.

Set at an angle and widely spaced, the overlapping abrasive flaps reach into corners.

With more flaps than standard discs, these last 30-40% longer.

With more flaps than standard discs, these last 30-40% longer.

Replace your sanding discs less often—the backing plate on these discs can be trimmed off as the abrasive flaps wear down, allowing you to use more of the disc.

Set at an angle and widely spaced, the flaps reach into corners.

Set at an angle and widely spaced, the flaps reach into corners.

The abrasive flaps wrap around the outer edge of these discs to reach in and sand welds at right angles (fillet welds).

Change your sanding belts less often—these belts have a zirconia alumina abrasive that continuously fractures to form new sharp edges. These self-sharpening edges are great for aggressively removing material on steel and wood.

These belts last at least 50% longer and sand faster than standard ceramic alumina belts.

Use these narrow belts on hand-held sanding sticks.