These rolls are coated with aluminum oxide, which is the most common abrasive material and hard enough to sand steel and wood.

These rolls resist deterioration when used wet or with grease, chemicals, cutting fluids, and other solvents that may be present when sanding.

Use these rolls to create consistent finishes on hard metals such as stainless steel, iron, and nickel.

A coating prevents dust and debris from building up on the abrasive surface.

The ceramic alumina abrasive on these discs is sharp and dense enough to shape hard metals such as stainless steel, nickel, and cast iron without dulling quickly.

Coated with either ceramic alumina or a premium form of aluminum oxide, these discs last longer, cut faster, and produce a more consistent finish than standard hook and loop discs.

Quickly sand while capturing up to 97% of the dust generated.

The premium abrasive lasts longer as well as cuts faster and produces a more consistent finish than standard hook and loop discs.

The premium abrasive stays sharp longer.

These belts resist deterioration when used with water or cutting fluids.

Create finer and more consistent finishes—these belts have a cushioned layer that creates more even sanding pressure on your workpiece.

Flexible flaps reduce gouging while producing a uniform finish on flat and curved surfaces. They provide more control than a standard sanding sleeve but are more aggressive than a traditional flap wheel. As the flaps wear, new abrasive is exposed.

Choose a bit with the same angle as your countersink to debur the inside of the hole.

The flaps are slit into narrow strips to provide more flexibility than other flap wheels.

The threaded stud allows faster wheel changes but requires the use of an adapter in your tool.

Polish, clean, and debur deep inside tubes and cylinders.