When compared to standard 304 stainless steel, this material can be machined faster with less wear on cutting tools. It's also called Prodec and Project 70+.

This material has tighter tolerances than standard 304 stainless steel.

Bend this wire and it will stay put. It’s frequently used as tying wire and locking wire.

Widely used for fabricating fittings and fasteners, 303 stainless steel machines quickly without sticking to cutting tools.

Offering outstanding resistance to surface wear and corrosion, Nitronic 60 stainless steel is often used for shafts, fasteners, and valves.

This material is precision ground to offer tighter tolerances than standard 316 stainless steel.

This wire will spring back after bending. It's often used to make springs and wire rope.

This material machines faster with less wear on cutting tools than standard 316 stainless steel. It's also called Prodec and Project 70+.

2205 stainless steel resists cracking even when faced with a combination of tensile stress, corrosive chemicals, and heat. Also known as duplex stainless steel, it has twice the strength of 316 stainless steel. Use it for high-pressure applications in caustic environments.

Precision ground to a tight diameter tolerance, these rods are all set for turning applications in a lathe.

Bend this wire and it will stay in place. It's commonly used as tying and locking wire.

With a diameter that’s held to a close tolerance, this material is hardened for increased wear and abrasion resistance.

One of the hardest types of stainless steel after heat treating, 440C offers excellent wear and abrasion resistance. It's often used for bearings, valves, and knife blades.

Able to withstand temperatures up to 2100° F, 330 stainless steel is widely used as components for industrial furnaces, gas turbines, and boilers. It resists cracking when exposed to heating and cooling cycles.

Widely used to fabricate fasteners and engine components, A286 will maintain its strength as temperatures rise.

Hardened for improved strength and wear resistance, these rods are precision ground to a strict diameter tolerance. Use them for turning applications in your lathe.

Also known as Project 70+, this material machines faster with less wear on cutting tools than standard 17-4 PH stainless steel.

This material is hardened for improved strength and wear resistance.

These shafts have keyways only on the ends, leaving a plain shaft in the center. Use the keyways with machine keys to transmit torque to gears, sprockets, and other keyed components. Use the middle of the shaft with bearings and other round-bore components.

A shoulder near the end of the shaft provides a stop for gears, sprockets, and bearings.

The diameter of these shafts is slightly smaller than listed, so precision ball bearings (ABEC-3 and above) slide on without any tools.

Internal threads allow you to mount these shafts onto threaded studs and fasteners, no shaft supports needed.

Replace worn shafts in two-piece support-rail shaft systems, or mate with a support rail to create your own. The tapped mounting holes match those on our Support Rails.

These shafts have one threaded end to fit threaded propellers and one machined end to fit mixer shaft couplings.

Typically used with thin-wall stainless steel unthreaded pipe fittings.

Typically used with extreme-pressure stainless steel unthreaded pipe fittings.

Typically used with standard-wall and low-pressure stainless steel unthreaded pipe fittings.

Typically used with low-pressure stainless steel threaded pipe fittings.