Move belts forward and backward or stop and start them in precise positions, especially in areas where rust is a concern.

Mount these high torque drive (HTD) pulleys onto a hex shaft.

Curved teeth with a high pitch provide superior load distribution and reduce wear. They mount with a bushing for a more secure grip on the shaft than set screws.

Acetal and aluminum construction makes these pulleys useful in for weight-sensitive applications.

Pulleys are anodized aluminum, which is more corrosion resistant than steel.

These L series (light) pulleys and have trapezoidal teeth.

Move heavy loads without slippage—pulleys mount with a bushing for a more secure grip on the shaft than set screws.

Made from polycarbonate, these pulleys are useful in applications with weight constraints.

Made of aluminum, these pulleys have good corrosion resistance.

To prevent slippage while moving extra heavy loads, these pulleys mount with a bushing for a more secure grip on the shaft than set screws and press-fit pulleys.

Securely carry heavy loads—these pulleys mount with a bushing for a better grip on the shaft than set screws and press-fit pulleys.

These pulleys are cast iron.

Also known as step-cone pulleys, these have multiple groove sizes so you can quickly change rotation speed by moving your belt to a different groove.

Use these pulleys with compatible quick-disconnect bushings.

These pulleys have the same sizing versatility as quick-disconnect pulleys, but they create a tighter grip on bushings for use in high-torque applications.

These pulleys spin freely on built-in bearings to maintain tension for reduced wear and vibration.

Also known as paper-plant pulleys, these are made of a paper-fiber composite that minimizes belt slippage and wear.

Mount these pulleys to a flat surface to assist with horizontal pulling or to guide a rope.

Also known as snatch blocks, these open so it’s easier to feed the rope through the housing—a free rope end is not needed.

Mount these pulleys to a flat surface to assist with horizontal pulling or to guide a rope.

Also known as snatch blocks, these open so it’s easier to feed the rope through the housing—a free rope end is not needed.

Mount these pulleys to a flat surface.

Also known as snatch blocks, these open so it’s easier to feed the rope through the housing—a free rope end is not needed.

Also known as snatch blocks, these open so it’s easier to feed the rope through the housing—a free rope end is not needed.

A rubber coating, also known as lagging, increases friction for a better grip on the belt.

The corrosion-resistant stainless steel construction makes these pulleys suitable for washdown applications.

Slide these coating strips into metal retainers that you attach to your pulley—they add friction that helps conveyor belts stay on pulleys and are replaceable when they’re worn.

Made of high-strength ductile iron, these wheels withstand impact better than other wheels to open and close large or stubborn overhead valves from the floor. They can also be used to operate hatches, skylights, and other overhead components.