Typically used with low-pressure brass and bronze threaded pipe fittings.

Use these fittings in low-pressure flow applications. They have good corrosion resistance.

The male threads on these brass fittings have a sealant applied for extra protection against leaks. Also known as Pressure Class 125 fittings, they are built for use in low-pressure applications.

Connect this pipe to standard-wall plastic pipe fittings for a variety of residential and commercial low-pressure plumbing and water supply applications.

Connect these fittings to Schedule 40 plastic pipe—they are the industry standard for residential and commercial low-pressure plumbing and water supply applications. They are plastic for good corrosion resistance.

Connect to thick-wall plastic pipe fittings for use in heavy duty industrial plumbing and water supply applications, such as water processing, waste water treatment, and irrigation. Pipe can handle pressures up to 900 psi.

Connect these fittings to Schedule 80 pipe. With thicker, stronger walls than standard-wall fittings, they can handle heavy duty supply applications, such as water processing, wastewater treatment, and irrigation.

Connect to barbed plastic pipe fittings with a clamp. Pipe isn't as bendable as soft tubing, but can still bend around objects, resulting in fewer connection points in your line. Fewer connection points not only shortens installation time, but also allows for smoother flow through the line.

Connect to CPVC pipe fittings for use in high-temperature plumbing and water supply applications up to 170° or 200° F.

Bolt two same-size flanges together with a gasket to create an access point within a line. They are also known as Pressure Class 150 flanges. Use in high-temperature plumbing and water supply applications up to 200° F.

The inside of this pipe won’t leach contaminants into your line or accumulate particles—it’s polished to an ultra-smooth 12 Ra finish, which also makes them easy to clean. Made of polypropylene, it resists organic solvents, acids, and alkalis better than CPVC pipe.

The inside of these flanges won’t leach contaminants into your line or accumulate particles—they’re polished to an ultra-smooth 12 Ra finish, which also makes them easy to clean. Made of polypropylene, they resist organic solvents, acids, and alkalis better than CPVC pipe flanges.

This Type L tubing has thicker walls than Type M tubing. It withstands pressures up to 1,500 psi.

This Type K tubing has the thickest walls of all our copper tubing for drinking water. It withstands pressures up to 1,900 psi.

Solder these fittings to tubing for a permanent, leak-tight connection. They are also known as sweat fittings.

Crimp these fittings to copper tubing with a crimping tool for a leak-tight connection that doesn’t require heat or soldering. They are comparable to Viega ProPress fittings.

Made of plastic, these fittings are lightweight compared to our brass push-to-connect fittings.

Connect stainless steel tubing on one end and plastic tubing on the other end.

This tubing has hard walls like copper tubing, but is lighter in weight and easier to install. It connects to fittings with no heat or soldering required. Tubing meets NSF/ANSI Standard 61 for drinking water.

Use these nuts with brass compression fittings to create a seal on plastic tubing. They meet NSF/ANSI 61 for use with drinking water.

Create a push-to-connect junction in equipment with these fittings. To install, drill a stepped hole in your surface, push the fitting components into place, then insert your tubing.

Connect these fittings to tubing with a ring and a crimping tool (both sold separately). Safe to use with drinking water, these fittings meet the strict standards of NSF/ANSI 61.