In addition to a low-friction surface that prevents sticking and binding, this tough material is impact and wear resistant to handle the scuffs, scrapes, and strikes that other plastics can’t.

More sustainable than standard UHMW, these sheets and bars are made from partially recycled material, so they have a lower carbon footprint.

Made with carbon black, these recycled UHMW sheets are a sustainable alternative to standard UHMW sheets in applications where static electricity is a concern, such as in conveying equipment and chute liners.

The addition of carbon gives this material the ability to divert static electricity faster than antistatic UHMW.

Compared to our standard UHMW polyethylene, these sheets and bars hold up better to scuffs and scrapes in high-speed, high-precision, and high-impact applications—such as conveyor equipment, chute liners, and machine guards. Also known as Tivar HPV.

If a chip of this material breaks off, it can be located by metal detectors to reduce contamination risks.

Practically nonabsorbent, HDPE won't swell when exposed to moisture. It is denser and more rigid than LDPE, plus it's more chemical resistant.

Because PVC resists many acids and alkalies, it’s widely used for tanks and in chemical-processing applications. Also known as PVC Type 1.

Offering greater impact resistance than standard PVC Type 1 with similar chemical resistance, this PVC Type 2 is widely used for parts that are subject to shock.

Create signs and partitions with this easy to cut PVC foam.

Often used to make gears and wear strips, these cast nylon 6 sheets and bars withstand higher temperatures and are easier to machine than standard nylon 6/6 sheets and bars.

This nylon stays lubricated over time because it’s filled with oil. Use it to fabricate parts for hard-to-reach places where adding lubricants would be difficult.

Often used for packaging and construction applications, this film is also known as Visqueen.

Known for its electrical insulating properties, this polystyrene is often used for cable connectors, electrical housings, and in microwave applications. It is also known as Rexolite.

This film is often used as a separator when heating parts in an oven.

These black polyester sheets protect from UV rays better than off-white polyester. Strong and semi-rigid, they won't swell in moist environments, so they're often made into pump components and spacers.

Made with Teflon® PTFE resins, these sheets and bars surpass most plastics when it comes to chemical resistance and performance in extreme temperatures.

This film is made with virgin Teflon® PTFE resins. It can handle extreme temperatures and resists most solvents.

Manufactured from Rulon PTFE, a PTFE that's modified with filler material for a super-slippery, impact-resistant surface that resists wear.

Protect sensitive equipment from damaging electrical static charges.

This film conducts electricity to prevent the buildup of static charges.

Not only does PEEK provide superior wear resistance in repetitive processes, it is also resists wear caused by abrasion. PEEK can be used as a lightweight substitute for metal parts in chemical-processing applications.

These PEEK sheets can be machined to tight tolerances for use in electrical and semiconductor parts, such as test sockets.

Stronger than PTFE, PVDF offers good chemical resistance. Comparable to Kynar and Solef, it’s widely used for pump parts, tank liners, and seals.

Just as chemical resistant as PTFE, yet FEP offers greater impact strength. Use it to make valve components and gaskets.

A static-dissipative coating on this cast acrylic prevents electrostatic discharge from damaging sensitive electronic equipment.

This polycarbonate has a static-dissipative coating that prevents electrostatic discharge from damaging sensitive electronic equipment.

Carbon mesh is embedded into this clear PVC film to dissipate electrostatic discharge and protect sensitive electronic equipment.

Because PVC resists acids and alkalies, it is often used in tanks and chemical-processing applications where visibility is essential.

The slippery surface on this FEP film prevents sticking. Use it as a release film when making molded parts.