A rubber seal and stainless steel hardware give these connectors excellent chemical resistance. They're rated NEMA 12, 4X, and IP65 for protection against corrosion, oil, and washdown environments.

Configure a connector for your application—combine inserts for power and signal with a base and a hood.

Build a connector that fits in tight spaces by combining male and female inserts for power and signal with a compact base and a hood.

Carry up to four times the current of standard Compact Latching Connectors. The base and hood latch together securely, yet can be quickly detached for equipment repair or replacement.

Connectors come assembled with wire leads already installed, so they can be quickly added to existing wiring systems. Use them with AMP MATE-N-LOK connectors.

Sets include a plug and socket with wire leads already installed, so they can be quickly added to existing wiring systems. They fit standard Molex plugs and sockets.

Stack as many connectors on top of each other as needed—the housings clamp together to form a secure attachment.

Rated to MIL-DTL-5015 specifications, these connectors are compatible with other products that meet the same standard. They screw together for a secure connection.

These connectors meet MIL-DTL-26482, so they're compatible with other products that meet the same standard. Quickly mate by pushing them together.

Configure a connector for your application by combining housings with pins and sleeves for different wire sizes. Also known as weather-pack connectors, they withstand moisture, harsh engine fluids, and high temperatures.

Use these connectors in vehicles and other agricultural and construction equipment.

These connectors meet international standards IEC 309-1 and 309-2. They prevent an electrical arc when separating mated connectors, so you can safely connect and disconnect with the power on.

Use connectors where ignitable gas and dust may be present, such as in refineries and silos. They also prevent an electrical arc when separating mated connectors so you can safetly connect and disconnect with the power on.

When used together, connectors maintain a watertight and corrosion-resistant NEMA 4X connection.

With a PVC housing, connectors withstand exposure to chemicals, oil, fuel, and salt water.

Connect wires to your circuit board with these Molex KK push-in connectors.

Attach wires to your circuit board with these Amphenol PV connectors.

One hand is all you need—just push these connectors in to secure them and charge surveillance cameras, user interfaces, and other small devices.

Reduce the number of electrical connections in sanitary areas, such as food plants—these connectors combine Ethernet, a power cable, and wire for signals into a single connection point.

Push these connectors together to quickly create signal and data connections in tight spaces. They need less space to mate than screw-together connectors, which require two hands to twist them in place.

Connect multiple M8 and M12 cords to create a network between equipment. These blocks are often used to send signal and power to proximity switches and sensors.

Couple these adapters with a cord that matches your outlet and length requirements to run DC-powered electronics.

With plug-in connectors on both ends, this wire extends the reach of your thermocouple. It’s protected by a stainless steel armor that also resists corrosion and wear.

No need to take these connectors apart—just insert your wire leads and tighten the terminals to quickly give your thermocouple a plug-in connection.

Convert round-pin thermocouple connectors to flat-pin mini thermocouple connectors.

Already mounted in a conduit box, these connection strips save you the effort of modifying a panel for installation.

Convert 10-pin cables to RS-232C for connection to PCs.