We will reply to your message within an hour.
Push down to create a vacuum and grip your items.
A built-in pump generates more suction for lifting and holding heavier items than push-grip lifters.
For a strong, continuous grip, these lifters have levers to lock them in place.
Easily grab iron and steel fasteners, small sheets, and other parts from work areas, bins, and hard-to-reach places.
Slide steel plates and blocks off a stack.
Lift metal plates by hand by gripping the edge.
Move large, heavy sheets of plywood, fiberboard, cement board, and drywall with these nonmarring lifters. Unlike suction-cup and magnetic lifters, they will hold porous and nonmagnetic sheets.
Pull the on/off handle to engage and release the magnet.
These magnets hold a load until you pull the handle and pry the magnet off.
Pads on these clamps prevent the grip from biting into the load.
Use these clamps to raise a metal plate straight up from its original vertical position.
Use in pairs with a two-leg sling to transfer metal plates in a horizontal position. Unlike other plate-lifting clamps, these can pick up multiple plates at the same time.
Clamps can take a metal plate that is stacked horizontally and tilt it up 90° to lift vertically. After lifting, clamps can place the plate back down in the original position (plate can not be flipped over).
Separate stacked steel sheets without prying, scratching, or bending them.
Pick up screws, nuts, and other small steel objects.
A fluorescent orange handle makes these retrievers stand out, so they’re less likely to be misplaced.
LEDs light the magnetized tip for picking up screws, nuts, and other small steel objects in dark areas.
Often used to pick up steel sheets, the magnet holds material until you press the lever to disengage it.
LEDs light the magnetized tip and the shaft bends and stays in position to reach objects in awkward spaces.
Bend the shaft to reach objects in awkward spaces.
The head pivots, so you can pick up screws, nuts, bolts, and other small steel objects from any angle.
Bend the shaft of these retrievers to access hard to reach spaces and pick up objects using the claw or magnet.
Made of steel for durability, these trucks have removable rails that allow you to configure them to accommodate a variety of long, flat loads.
These easy-to-clean, corrosion-resistant plastic trucks are reinforced with steel for strength. Removable rails allow you to configure them to accommodate a variety of long, flat loads.
Load these trucks from either side to make quick work of moving large quantities of long, flat material such as doors, partitions, and sheet stock.
Add wheels to a door, partition, or piece of sheet stock to make moving a one-person job.
Designed for temporary mounting on smooth, nonporous surfaces, vacuum holders are easy to remove and reposition.