Impregnated with oil, these tubes remain slippery over time. Use them to fabricate pulleys, bushings, and bearings for use in hard-to-reach areas where adding a lubricant would be difficult. Because they are made of cast nylon 6, they are easier to machine than standard nylon rods, plus they’re better electrical insulators. The OD is oversized and the ID is undersized for finishing to the sizes listed. This material is comparable to Nycast and Nyloil.

For technical drawings and 3-D models, click on a part number.

Startup friction causes these bearings to release a thin layer of oil on the bearing’s surface. They’re flanged, so they handle loads both parallel and perpendicular to the shaft. They’re also known as Oilite® bearings.

Nylon bearings resist chemicals better than bronze bearings. They also retain oil better in wet environments.

Note: Dynamic load capacity is the maximum load a bearing can withstand at a given shaft speed. If your application’s load and speed requirements are below the values listed, the bearing will work.

For technical drawings and 3-D models, click on a part number.