Easy to use, strong, and versatile, these hose clamps are the most common. Tighten their slotted screw with a screwdriver, hex nut driver, or wrench.

A raised safety collar around the head of the screw prevents your screwdriver from slipping and damaging the hose or tube.

An extended tail acts as a liner to protect hose and tube from being cut by the slots in the band.

Socket-connect fittings are easier to weld than butt-weld fittings because the fitting doesn't need to align perfectly to the pipe. Slide the pipe into the socket and weld.

A molded cushion reduces vibration and wear from clamp edges, plus it provides a tighter fit around material than standard vibration-damping loop clamps.

Attach these clamps to the flange of an beam, then hang a threaded rod from the threaded hole.

For centered load distribution, these clamps grip both sides of the beam and hang threaded rod from the middle.

Mount these general purpose U-bolts into an existing bracket, or combine with a mounting plate for a secure hold at the mounting surface.

A time-saving alternative to strap hangers, these hangers fit a range of material sizes without any cutting and easily adjust after they’re installed.

These hangers have a swivel nut for adjusting direction after mounting. They're also known as teardrop hangers. Combine with a threaded rod or other fastener to hang from the ceiling.

Mount bundles to surfaces with a screw or fastener. Since the mounting grommet on these ties is not accessible after material has been bundled, these ties are best for a permanent installation.

These clamps must be oriented with the saddle on the long (live) end and the U-bolt on the short (dead) end. They’re also known as wire rope clips.

Constructed with a saddle for both the long (live) end and the short (dead) end, these clamps apply equal pressure without crimping or crushing the wire rope, so orientation doesn't matter. Also known as fist grip wire rope clips.

These compression sleeves are designed to meet lifting specifications.