We will reply to your message within an hour.
Make clean cuts through duct tape and other sticky materials.
S-shaped handles keep your hand clear of material, so you can cut flush against flat surfaces.
These small scissors have narrow, sharp tips for fine cutting and trimming.
Prevent snags and injury with the rounded points on these small scissors.
Short blades make these scissors easy to maneuver in cramped areas for small, detailed cuts less than an inch long.
Trim flush against a flat surface with the curved blades on these small scissors.
Cut through the strong fibers of Kevlar.
For extra leverage to cut through Kevlar, metal, and plastics, these scissors have long handles and short blades.
After each cut, the jaws spring open to make continuous cutting easy.
Also known as electricians' shears, the back edge of the blade has a file to clean contacts.
Insulated handles protect against shock from accidental contact with live electrical circuits. These scissors are tested to 1,000 volts to meet IEC 60900 and ASTM F1505.
Cut and strip wire in tight spaces with the compact tips on these scissors.
Protect sensitive equipment from harmful static discharges while cutting and stripping wire.
These cutters make straight cuts and curves.
Blades are tapered to give you more control when cutting straight lines, tight curves, and circles, and they're serrated to prevent slipping. These cutters are also known as duckbill snips.
Also known as bulldog snips, these have long handles and short blades for cutting through thick sheet metal with less effort than standard sheet metal cutters.
Replace blades as they wear. These cutters are also known as tinners' snips.
Made from aluminum bronze, the blade and handle on these cutters inhibit sparking and are FM approved. Use them for straight cuts.
Handles are angled to keep your hand away from the material as you cut straight lines and curves.
Loosen a few screws to swap dull blades with new ones. These cutters have offset handles to keep your hands clear of the metal being cut.
The unique shape of these cutters gives you 40% more power per cut than standard sheet metal cutters. When blades get dull, loosen a few screws to replace them.
Sized and shaped like pliers, these sheet metal cutters are small enough to fit in your tool belt.
Keep your hand away from the material being cut.
Blades are high-speed steel so they stay sharp longer than steel blades, and they can be sharpened.
The handles are angled 90° from the blade so you can cut material from directly above tight spaces.
A double hinge provides high cutting force with low gripping pressure. These cutters are also known as aviation snips.
Snip tighter curves in smaller spaces than standard high-force cutters.
Make straight and curved cuts in sheet metal—these sets come with three tools for different cutting patterns. Also called aviation snips, they have a double hinge, so they cut with more force and require less effort to squeeze the handles than standard sheet metal cutters.
This cutter has two blades that cut a 1/8" wide strip—peel it back for smooth edges with little distortion.
Prevent waste from flying up as you work. A double blade makes two cuts to create a 7/64"-wide step that peels back, leaving little distortion and smooth edges.
Also known as scissor-blade shears, the bottom blade remains stationary while the upper blade moves up and down to cut metal up to 1/64" thick with minimal material loss and edge distortion.
Minimize material loss and edge distortion with these scissor-like cutters that cut metal up to 1/64" thick.
Convert your drill into a sheet metal cutter to make quick, low-effort cuts without a separate power tool.
Leave clean cut edges in a variety of pliable materials.