These 410 stainless steel screws are more corrosion resistant than ultra-corrosion-resistant coated steel screws.

These blue and silver ultra-corrosion-resistant coated steel screws stand up to wet environments.

Attach the components of these sets onto a hammer drill to install tapping screws in concrete, block, and brick.

Also known as mungo anchors, these have large fins that prevent rotation.

Also known as lag shields, these anchors are designed for use with large-diameter wood screws.

These 18-8 stainless steel anchors have good chemical resistance.

Keep fixtures solidly in place—these anchors have two locking wedges that won't shake loose.

A zinc plating provides corrosion resistance in wet environments.

An open-end cap nut provides a finished appearance.

Also known as drive rivets, install by hammering the screw into the body. Unthread the screw to remove.

Also known as drive rivets, install these anchors by hammering the pin into the body. Pry out the pin to remove.

Use in applications requiring high strength.

Also known as tap-in or uni-tap rivets, these anchors are barbed to resist pull out. Made from nylon, they're chemical resistant.

Also known as caulk-in anchors, these stay secure when there's not much material to hold.

A zinc plating provides corrosion resistance in wet environments.

More corrosion resistant than 18-8 stainless steel anchors, these 316 stainless steel anchors have excellent resistance to chemicals and salt water.

These 316 stainless steel anchors have excellent resistance to chemicals and salt water.

A hex head allows for a secure grip with a wrench.

A pivoting toggle bar creates a strong hold.

Used with adhesive in bricks and hollow blocks, such as cinder blocks, these mesh tubes create a stronger hold for rods and studs than other anchors.

18-8 stainless steel anchors have good chemical resistance.

These steel anchors are available with corrosion-resistant finishes.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.

A built-in stop ensures repeatable drilling depths for installing drop-in anchors.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.

Use these diamond-coated hollow bits for wet drilling of masonry, concrete, and rebar with a drilling rig.

These bits have a round or hex shank that fits into the three-jaw chuck on a hammer drill.

Drill holes up to 1 1/2" in diameter.

The 1/4" hex shank allows these bits to be used with standard impact drivers.

These hollow bits cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

These hollow bits cut with their outside edge for drilling holes larger than 1 1/2" in diameter.

The SDS-Plus shank has two deep slots and two shallow slots for use with SDS-Plus-drive rotary hammers.

A more controlled chip removal reduces heat buildup. Use these bits on brittle materials such as block and brick.