Turn the dial to control the percentage of time that these heaters cycle on, from 5% to 100%. Commonly used to thaw pipes, prevent valves from freezing, and heat beakers and flasks in labs, they're good for temporary and occasional use where rapid heating is required but precise temperature control is not.

Wrap the flexible heating element around small-diameter pipes and tubes or pack it into tight spaces.

Rated for a maximum heat output of 900° F, these heaters are often used for thawing frozen pipes and rapid spot heating.

Also known as self-regulating heat cable, these heaters automatically adjust heat output at different points along their length to account for differences in environmental temperature.

Keep the liquid inside your hose from freezing, maintain your liquid’s viscosity, and prevent condensation in chilly environments.

Also known as circulation heaters, these install directly into pipelines.

Also known as circulation heaters, these install directly into pipelines.

Stick these flexible heat sheets to container surfaces to warm contents without direct contact.

Less than 0.015″ thick and highly conformable, these heat sheets warm components in tight spaces within complex designs.

Also known as foil heaters, these bend around corners and edges without causing damage to the heating element.

Also called tankless water heaters, these provide hot water on demand and take up less space than heaters with a tank.

An adjustable thermostat automatically turns the heater on when the temperature drops below your set temperature and off when it rises above your set temperature.

With more than three times the pressure rating of standard heat exchangers, these are often used for high-pressure condensing, evaporating, heating, and cooling. They are also known as shell and tube heat exchangers.

Stacked, corrugated plates maximize contact with liquid or steam flowing through these brazed plate heat exchangers for faster heat transfer than shell and tube heat exchangers.

The heating wire in this hose warms adhesives or paraffin wax to keep them flowing. Pair it with the matching temperature controller to set the temperature.

Heat chemicals to prevent them from freezing or becoming too thick. With a self-regulating heating wire, the liquid inside this hose stays warm and keeps flowing.