We will reply to your message within an hour.
More
These steel screws cut threads in drilled holes as they’re turned, so they require less driving torque and cause less stress on your material than thread forming screws.
Made from 410 stainless steel, these screws are strong, wear resistant, and mildly chemical resistant.
A Torx drive has more points of contact than a Phillips drive, allowing you to apply extra force with less slippage or damage to the recess.
These steel screws are zinc plated to resist corrosion in wet environments.
A wide cutting slot provides excellent chip clearing and low driving torque in soft metal.
These screws have a hex head for a secure grip with a wrench.
Also known as Swageform screws, threads at the tip are designed to grab material for a fast start with low torque in a wide range of materials.
These metric thumb screws have arms that provide a flat surface to push your fingers against.
These metric thumb screws have wings that provide more leverage than spade-head thumb screws for greater torque while tightening. A zinc plating provides corrosion resistance in wet environments.
Wings provide more leverage than spade-head thumb screws for greater torque while tightening. A zinc plating provides corrosion resistance in wet environments.
Mount these knobs into a threaded hole. They provide a secure grip to position, tighten, and hold fixtures, equipment, and machinery.
Mill specific holes or keyways in the hub to meet your specifications, or weld in place. These knobs provide a secure grip to position, tighten, and hold fixtures, equipment, and machinery.
Mill specific holes or keyways in the hub to meet your specifications or weld in place. Insert a bar between the arms and twist. The bar provides maximum leverage to tighten knobs securely.
To provide corrosion resistance in wet environments, this framing is galvanized.
Also known as single-start and self-locking lead screws and nuts, these have a single thread that runs the length of the screw. The nut travels only when the screw turns, so your system won't unexpectedly move when the lead screw is at rest.
Multiple thread channels (also known as thread starts) create faster linear travel than lead screws with a single thread start.
Found in hand-powered clamps, vises, grates, doors, and work tables, lead screws and nuts have broad, square threads that are well suited for quick assembly, high clamping forces, and lifting and lowering heavy objects.
Broad, strong Acme threads make these screw jacks better than ball screw jacks for heavy loads, intermittent positioning applications, and where vibration is present.
Low-friction ball bearings allow these screw jacks to use half the power required by an Acme screw jack to lift the same load. Typically used as actuators, they run at higher speeds than Acme screw jacks.
Combine fast-threading components to build a clamping assembly.
Add on to an existing screw conveyor or keep it running like new.
Add an eye nut to threaded rod to hang the rod from rings, hooks, and hangers.