A ratchet mechanism allows you to drive fasteners when there's little space to move the handle.

Style A have an offset head to access screws in obstructed areas. A retaining ring holds the bit, and the plastic handle provides comfort and a secure grip.

Style B accept two shank sizes, held in place by magnets.

Style C accept two shank sizes and have offset heads to access screws in obstructed areas. Magnets hold the bits.

Style E have seven interchangeable bits—all of which are compatible with power tools. Store them inside the handle so they don’t get lost or misplaced when you’re not using them. Bits are held in place by magnets. To use these screwdrivers as a nutdriver, remove the bit and turn fasteners with the shaft.

Drive screws four times faster than ratcheting alone. Grip the speed housing at the base of the shaft with one hand while turning the handle with the other. These tools have a magnet at the end of the shaft that holds bits in place. The contoured ultra-grip handle provides comfort and the best possible grip for achieving maximum torque.

LEDs light the tip so you can use these tools in dark areas. Bits have a different tip at each end and snap into the shaft.

An insulated handle and shaft protect against shock from accidental contact with live electrical circuits. These tools are tested to 1,000 volts to meet IEC 60900 and EN 60900. A magnet holds the bit in place.

Bits have a different tip at each end and snap into the shaft. A ball detent holds the bit in place. To use as nutdriver, remove the bit and turn fasteners with the shaft, which is also reversible.

Ultra-grip drivers have a multicomponent handle that provides comfort and the best possible grip for achieving maximum torque. For those without a voltage detector, bits turn four screw sizes and the shaft two external hex sizes. Those with a voltage detector safely test for AC voltage without contacting live wires. Light and sound indicators alert you when over 50 volts AC is detected. The detector is attached to the tool’s handle; remove it from the handle to use it on its own. Bits turn eight screw sizes and the shaft three external hex sizes.

Cushion-grip drivers offer comfort and some slip resistance. Bits turn eight screw sizes and the shaft three external hex sizes.

When working in tight spaces, these short drivers fit where others can't. Bits have a different tip at each end and snap into the shaft. A ball detent holds the bit in place. To use as nutdriver, remove the bit and turn fasteners with the shaft, which is also reversible and turns two external hex sizes. Drivers have a cushion grip for comfort and some slip resistance.

Fasten differently sized screws with these sets. They save you the effort of switching three separate bits in and out of a power tool, instead letting you flip between a countersinking drill and a screwdriver bit with a single hand. You can also attach your own countersinking drills and screwdriver bits as long as they have a 1/4” hex shank.

Countersinking drills have an 82° angle, allowing inch-sized flat- and oval-head screws to sit flush with the surface.

Drill, countersink, and drive screws without switching three separate bits in and out of your power tool. With a single hand, flip between drilling countersunk holes and driving screws. The countersinking drill and screwdriver bit are secured with set screws, so you can switch them out for any bits with a 1/4” hex shank.

The countersinking drill has an 82° angle, allowing inch-sized flat- and oval-head screws to sit flush with the surface.

For technical drawings and 3-D models, click on a part number.