We will reply to your message within an hour.
For easy interchangeability, the mounting footprints of these cylinders meet NFPA and JIC industry standards.
With a small body size, these cylinders fit into tight spaces but offer similar push forces to standard hydraulic cylinders.
Small yet powerful, these cylinders thread into a system for workholding applications.
These cylinders have a magnetic piston that can be used with tie rod-mount proximity switches to electronically indicate piston position. For easy interchangeability, their mounting footprint meets NFPA or NFPA and JIC industry standards.
Made of 303 stainless steel, these hydraulic cylinders move heavy loads without corroding in wet areas.
Push one heavy load while pulling another. These hydraulic cylinders have a rod that runs through both ends, so when it extends on one end, it retracts on the other.
These kits include the rod gland with all of the seals installed.
Replace all the seals on the piston of a hydraulic cylinder.
Pump the handle by hand to raise the jack. Turn the release valve to lower the load.
Jacks are equipped with two foot pedals for hands-free use, one to raise the ram and another to lower it.
Use these versatile jacks for lifting, spreading, bending, pushing, and straightening.
These jacks have a short body to fit in low-clearance spaces.
With fewer moving parts than standard bottle jacks, these are made for frequent use.
Push or pry apart material with these rams by attaching them to a hydraulic pump.
Jacks include a ram, a hand pump with hydraulic oil, a pressure gauge, and a hydraulic hose.
These jacks include extensions for increasing lift height and accessories for prying.
Connect these pumps to a ram to create a hydraulic jack.
Connect up to four rams and a gauge to a pump. Ram connections have flow-adjustment valves to adjust ram speed, or shut it off to temporarily hold a load.
Connect up to five rams to a single pump.
This steel-reinforced hose has male threads.
Thread one of these plates onto your ram and use the four mounting holes to secure it in place.
Connect a hose to a ram or pump.
Use these fittings with hydraulic hose.
Control the flow of oil to adjust ram speed, or shut it off to temporarily hold a load.
Fit these compact jacks under low-height loads.
Roll from job to job and under hard-to-reach places.
As versatile as bottle jacks, but with two lifting points—a toe for lifting loads low to the ground, and a saddle for a higher, more stable lifting point.
Avoid common O-ring failure in dynamic applications—the square base of these seals prevents twisting, while backup rings protect against extrusion.
PTFE gives these seals a slippery surface that allows rod speeds more than two times faster than our other piston seals.
A square O-ring prevents these piston seals from rocking in the groove.
These Buna-N seals are reinforced with cotton thread for strength.
Rated for pressure up to 10,000 psi, these seals withstand the highest pressure of our piston seals.
Slip these bellows over hydraulic cylinder rods to keep them free from debris for a long service life.