Use to cut plastic and rubber tubing.

Fit this compact cutter into your pocket or tool belt. Use it to cut plastic and rubber tubing. It has a spring-loaded frame.

Cutters with a stainless steel blade resist corrosion.

Cutters with a bead chain or lanyard can be securely clipped onto a tool belt or other surface. Those with a lanyard do not need to be unclipped before use—the lanyard will stretch so you can make nearby cuts.

Slice through thick plastic pipe up to 2” in diameter in only three seconds. These cutters are light enough to carry around and are good for up to 200 cuts on a single battery charge. Easy to use with one hand, they make perpendicular cuts with the pull of a trigger. The harder you press down on the trigger, the faster they cut. They don’t leave any burrs behind on your pipe, so you’ll have a clean edge to install a fitting. Since the blade is stainless steel and the jaw is aluminum, you don’t have to worry about rust when cutting through wet pipe.

Unlike manual cutters, there’s no need to repeatedly make adjustments or rotate them around your pipe. This makes them good for confined spaces—they need less than half an inch of clearance to cut through a pipe installed near a wall.

To prevent accidental cuts, you have to press a safety button as you pull the trigger. They also have a button that folds the blade into the head to keep it out of the way when not in use.

The battery and charger are sold separately.

Avoid tiring your hand while making repeated cuts in a variety of material—from plastic pipes to wood dowel pins. These cutters ratchet to increase leverage, so they don’t require as much effort to squeeze the handles as standard multipurpose cutters. They slice through leather, plastic, rubber, and wood and come with multiple anvils for different jobs, reducing the number of tools you need to keep on hand. Made of stainless steel, their blade resists rusting if rinsed with water or rained on.

Swap out the anvils with the included L-key. For flat material, use the flat anvil. The 90° anvil stabilizes uneven material before you cut. For accurate cuts at precise angles, the miter angle anvil is notched at 15° from 45° to 120°. To stabilize pipes and tubes before cutting, use the anvils that match your tube OD.