Hose Manifolds

Filter by

System of Measurement

Pipe Size

Number of Outlets

Thread Type

Material

For Use With

Shape

Outlet Location

Number of Inlets

Manifold Flow Pattern

Fitting Connection

Maximum Pressure @ Temperature

Connects To

Component

Outlet Center-to-Center

Manifold Type

Length

Outlet Spacing

Dash Size

Connection Port

Gender

Finish

RoHS

REACH

Export Control Classification Number (ECCN)

DFARS Specialty Metals

Forward

How can we improve?

1,099 Products

How to Measure Threaded Pipe Size

Right-Angle Flow Rectangular Manifolds

Distribute air or fluid to multiple locations from a single supply source with these manifolds. They are also known as headers.

Dual-Section Right-Angle
Flow Rectangular Manifolds

These manifolds have two separate sections inside, so you can run two different substances through them without worrying about them intermixing. Also known as headers.

Cleaned-and-Bagged Right-Angle
Flow Rectangular Manifolds

Designed for ultra-clean environments, these manifolds are cleaned, dried, and vacuum sealed in plastic to prevent dirt and moisture from contaminating the inside. Use them to distribute air or fluid to multiple locations from a single supply source. Also known as headers.

Straight-Flow Rectangular Manifolds

Unlike other manifolds, which have an inlet on either end, these have one inlet on the opposite side from the outlets. This design allows air or fluid to follow a straight path, improving flow through your system. Also known as headers.

Round Manifolds for Hose Lines

Mount these manifolds on the end of a hose line to distribute air, water, or hydraulic fluid to three locations from a single supply source.

Low-Profile Square Manifolds

With outlets on the side instead of on top, these manifolds have a lower profile than rectangular manifolds and fit well in cramped spaces. Use them to distribute air or fluid to three locations from a single supply source.

Low-Profile Hex Manifolds

When you’re short on vertical space, these manifolds are a good fit—they have outlets on the side instead of on top, so they have a lower profile than rectangular manifolds. Use them to distribute air or fluid to five locations from a single supply source.

Miniature Hex Manifolds

A great solution when space is at a premium, these manifolds are less than an inch in height, yet allow you to supply up to 12 lines from one distribution point.

Color-Coded Irregular Hex Manifolds

Use these manifolds with molding equipment to circulate hot and cold water through your line. They have a red side for hot water and a blue side for cold water.

Straight-Flow Junction Blocks

Use these junction blocks to organize and separate multiple lines in your system. They have threaded holes that allow air or fluid to flow straight through the block.

Right-Angle Flow Junction Blocks

These junction blocks have threaded holes that allow air or fluid to flow at a 90° angle through the block. Use them to organize and separate multiple lines in your system.

ARO Quick-Disconnect Hose Couplings for Air

Compatible with ARO-shape plugs and sockets.

Industrial Quick-Disconnect Hose Couplings for Air

The industry standard for quick-disconnect couplings, these are also known as industrial interchange couplings. Compatible with Industrial-shape plugs and sockets.