Also known as blind-hole spotters, these punches fit into closed-end holes and mark the center of a complementary hole.

Fit these through existing holes and mark the center of the hole in a second workpiece.

These sets come with three punches for use with a variety of hole sizes. Insert one into an existing hole and twist the handle to open the end of the punch. The point automatically centers once the punch has fit the hole size.

Push down on the spring-loaded cone to center the punch in a variety of round and square hole sizes.

Also known as transfer screws, these punches have a uniform shoulder height so you can quickly transfer multiple hole locations at once.

The punches in these sets have a uniform shoulder height so you can quickly transfer multiple hole locations at once. Also known as transfer screws.

Locate and mark the centerline on rods, tubes, and pipes, lay out keyways, and establish angles for connections.

With an internal spring mechanism, these punches offer one-hand operation when marking hole centers.

Punch has two viewing lenses. One has a circle and dot and one has a crosshair to enable you to pinpoint the location where you need to punch. Replace the lens with one of the two included punches and strike it with a hammer to mark the hole center.

Also known as center punches, the tools in these sets mark hole centers in metal and other materials.

Ground to a sharper tip than other center-marking punches, these tools make the precision marks required for the intersection of lines and other detailed tasks. They're also known as prick punches.