Roll these powerful space heaters to where you need heat for big jobs. All have a built-in thermostat.

The electronic spark ignition makes them good for drafty areas where a pilot light could be extinguished. The safety shut-off cuts the gas supply if the flame goes out.

Built for big jobs, this is a powerful space heater. It has a built-in thermostat.

The electronic spark ignition makes it good for drafty areas where a pilot light could be extinguished. The safety shut-off cuts the gas supply if the flame goes out.

Carry these heaters to offices, workstations, and other small spaces. All have a built-in thermostat.

Plastic heater shuts off if tipped over or airflow is obstructed.

19,100 Btu/hr. heater has a bracket you can use as a stand or to mount to the wall or ceiling. When operating at 208 volts AC, maximum area heated and heat output are reduced by 25%.

Roll these heaters to warm people at large worksites.

For permanent installation, add a thermostat (sold separately). A relay (not included) is required between the heater and thermostat.

Place at large worksites and other well-ventilated areas. These heaters have a safety shut-off that cuts the gas supply if the flame goes out.

Propane heaters with a regulator have a NGO connection (the same connection between your gas grill and propane tank).

Barrier ring guard kits keep you from accidentally bumping into heaters. They are often used in areas with high foot traffic.

Stay warm at a desk, counter, or table. The housings for these heaters maintain a low temperature, so they’re safe to touch and minimize heat damage to surfaces if the heater tips over. These heaters will also automatically shut off if they tip over or overheat.

Control them with the on-off switch or a thermostat. Freestanding heaters have a built-in thermostat. Wall-mount/freestanding heaters have a built-in floor stand and can mount under desks. You can add an optional thermostat (sold separately).

Move these heaters to worksites, loading docks, and other cold spots to warm people in indoor and sheltered outdoor areas.

For permanent installation, add a thermostat (sold separately). For 480V AC heater, a relay (not included) is required between the heater and thermostat.

Built for outdoor use, these heaters warm people at worksites and other cold spots without access to electricity. Connect heaters to a propane tank and light with a match. They have a regulator with a NGO connection (the same connection between your gas grill and propane tank). All have a safety shut-off that cuts the gas supply if the flame goes out.

Combine high-volume airflow with low-heat output for warming and drying. These blowers tilt to direct airflow.

Noise-reducing blowers are quieter than all of the other blowers.

Blowers with a fixed airflow rate are portable, so you can carry them from job to job.

UL and C-UL Listed blowers meet U.S. and Canadian safety standards.

Use the optional wye adapters to direct air into two hoses for more complete drying.

Roll these lamps to your work surface and position the head anywhere along the stand, 18”-30” from what you want to heat. Use for spot-drying paint, adhesive, and other surface coatings and fillers. They’re also known as infrared and radiant heaters.

Adjustable-temperature lamp lets you regulate heat using three switch controls and up to seven bulbs (not included). Lamp is not for use with water-based primers and paint.

Fixed-temperature lamps have a head that rotates for horizontal or vertical positioning.

Note: Do not use in hazardous locations, such as enclosed areas exposed to fumes.