Extra-thick walls provide more protection against abrasion and tears than standard high-shrink-ratio tubing. This tubing shrinks down to 1/6th of its original ID, so it creates a tight seal over irregularly shaped objects.

The smallest heat-shrink tubing we offer, this tubing protects wire with a 0.017" and smaller diameter.

For better protection against abrasion, tears, and punctures, this tubing has thicker walls than standard tubing.

Create a water-resistant seal—this tubing has an adhesive lining that melts when the tubing is heated and bonds to the underlying surface.

Made of PVC, this tubing resists chemicals, oil, and solvents. The adhesive lining creates a water-resistant seal when heated.

Create a tight, water-resistant seal over irregularly shaped components. When heated, this tubing shrinks down to about 1/6th of its original ID, while an adhesive lining melts and forms a barrier around your component.

Often used to bundle batteries, capacitors, and other electronics, this tubing tightly conforms to objects, similar to shrink wrap. It has excellent resistance to chemicals, oil, and acids.

This tubing shrinks down to a quarter of its original ID, so it creates a tight seal over irregularly shaped objects. It withstands up to 500° F.

Use this tubing in applications where temperatures reach up to 500° F. It's often used to insulate electronic components.

Made of woven polyolefin/polyester fabric, this tubing has excellent abrasion resistance so it can be dragged over rough surfaces without damage.

Insulate and protect high-voltage devices. This tubing withstands higher voltages than standard heat-shrink tubing because it’s made of a flame-retardant material with excellent electrical insulation properties.

After being cleaned with alcohol, this tubing is bagged and sealed in a clean room. It's certified for material quality and purity.

Also known as halogen-free tubing, this tubing produces minimal amounts of smoke and gas if exposed to an open flame, so it can be used in enclosed areas such as ships and tunnels.

Even with walls as thin as tracing paper, this PET plastic tubing withstands tears and nicks. Thanks to its thin walls, it shrinks down in seconds instead of minutes and at lower temperatures than PVDF and FEP plastic tubing.

Seal the end of crimped connections, such as motor coils, to insulate and protect them from moisture and abrasion.

Keep general purpose tubing in a variety of sizes on hand.

Use this wrap with heat-shrink tubing to create a moisture-resistant seal. Apply it like tape around wire and cable, then slide the tubing over the wrap. The wrap melts when tubing is heated and bonds to the underlying surface.

Create a permanent seal without applying heat. This tubing is also known as cold-shrink tubing.

Shield shipments of metal equipment that could be exposed to the outdoors for long periods of time.

Cover objects with sharp angles and points with this film to protect them from sun, dirt, moisture, and damage.

Hold large shipments on a pallet tightly together during transport.

These bags are moisture resistant and can be closed with a heat sealer.

An additive in the material prevents static discharge from building up on the bag's surface.

Quickly tear these bags off the roll.

These plastic bags are more moisture resistant than paper bags.

Push down on the handle to create a seal. Also known as impulse sealers, these sealers use a timer that regulates the length of the heating cycle.

Systems include a cradle, a heat sealer, a heat gun, and a roll of film that shrinks when heated.

Clamp shut the jaws to seal bags.

Create an airtight seal around small parts to prevent damage from moisture and oxidation.