We will reply to your message within an hour.
More
Use this general purpose tubing to insulate and protect wire and cable.
The smallest heat-shrink tubing we offer, this tubing protects wire with a 0.017" and smaller diameter.
This tubing creates a tight seal over irregularly shaped objects.
Extra-thick walls provide more protection against abrasion and tears than standard high-shrink-ratio tubing. This tubing shrinks down to 1/6th of its original ID, so it creates a tight seal over irregularly shaped objects.
Access connections more easily than with standard heat-shrink tubing. Make a small slit in this tubing to peel it away.
For better protection against abrasion, tears, and punctures, this tubing has thicker walls than standard tubing.
Identify ground wire with this green-and-yellow striped tubing.
Use this tubing where wire and cable may be exposed to chemicals, oil, and acids.
Resistant to diesel fuel, gasoline, hydraulic fluid, and lubricating oil, this tubing is often used in vehicles.
Often used to bundle batteries, capacitors, and other electronics, this tubing tightly conforms to objects, similar to shrink wrap. It has excellent resistance to chemicals, oil, and acids.
Often used in automated applications such as robotics, this highly flexible silicone rubber tubing withstands continuous motion without cracking and tearing. It resists abrasion and can be dragged over rough surfaces without damage.
Made of woven polyolefin/polyester fabric, this tubing has excellent abrasion resistance so it can be dragged over rough surfaces without damage.
Create a water-resistant seal—this tubing has an adhesive lining that melts when the tubing is heated and bonds to the underlying surface.
Extra-thick walls provide better protection against abrasion and tears than standard moisture-seal tubing, as well as creating a water-resistant seal.
Made of PVC, this tubing resists chemicals, oil, and solvents. The adhesive lining creates a water-resistant seal when heated.
Insulate and protect high-voltage devices. This tubing withstands higher voltages than standard heat-shrink tubing because it’s made of a flame-retardant material with excellent electrical insulation properties.
A layer of conductive cloth protects wire and cable from signal interference caused by nearby equipment and devices.
Made of PVDF, this tubing has excellent cut and abrasion resistance. It has a flame-retardant additive that resists combustion and minimizes the spread of flames.
Approved for contact with food, this tubing is FDA Compliant 21 CFR 177.1330.
After being cleaned with alcohol, this tubing is bagged and sealed in a clean room. It's certified for material quality and purity.
A different shrink ratio on each end allows this tubing to fit over cable assemblies and wire harnesses with large connections, or around connectors with a 90° elbow.
Also known as breakout boots, these splitters insulate and seal the point where wire splits off from cable, or where cables exit from conduit.
Keep general purpose tubing in a variety of sizes on hand.
Maintain a supply of tubing in a variety of sizes that withstand abrasion, moisture, and chemicals.
Protect wire and cable without disconnecting them from an assembly. For a water-resistant seal, this tubing has an adhesive lining that melts when heated to bond it to the underlying surface.
Create a permanent seal without applying heat. This tubing is also known as cold-shrink tubing.
With a spiral-wound core, these end caps form a permanent seal on the end of your crimped wire or cable without heat or tools.
Protect thermocouple wire exposed to air in forging, die casting, heat treating, and other extreme-temperature applications.